Mazda 2: Wheel and Tire Specification

Mazda 2 2007-2014 Service Manual / Suspension / Wheel and Tire Specification

Standard tire

Mazda 2. WHEEL AND TIRE SPECIFICATION

Mazda 2. WHEEL AND TIRE SPECIFICATION

*3 Verify the tire label attached to the actual vehicle on vehicles without TPMS.

Spare tire

Mazda 2. WHEEL AND TIRE SPECIFICATION

WHEEL BALANCE ADJUSTMENT (ALUMINUM ALLOY WHEEL)

CAUTION:

Adhesive-type Balance Weight (Outer)

1. Remove the old balance weight from the wheel.

2. Remove the double-sided adhesive tape remaining on the wheel, then clean and degrease the bonding area.

3. Set the wheel on a wheel balancer, measure the amount of unbalance and the position with the mode set for knock-type balance weight.

4. Multiply the amount of unbalance by 1.6 to obtain the balance weight value.

5. Select a balance weight closest to the weight value and attach the balance weight on the position (outer) indicated by the wheel balancer.

Mazda 2. WHEEL BALANCE ADJUSTMENT (ALUMINUM ALLOY WHEEL)

Example calculation of balance weight value

23 g {0.81 oz}

    READ NEXT:

     Wheel Unit ID Registration

    NOTE: After the wheel unit replacement, registration of the wheel unit identification codes must be performed. ID registration can be done using the M-MDS, or not using the M-MDS. Using M-MDS 1

     Front Suspension

    FRONT SUSPENSION LOCATION INDEX Stabilizer control link (See FRONT STABILIZER CONTROL LINK INSPECTION.) Front stabilizer (See FRONT STABILIZER REMOVAL/INSTALLATION.) Front shock absor

     Rear Suspension

    REAR SUSPENSION LOCATION INDEX Rear shock absorber (See REAR SHOCK ABSORBER REMOVAL/INSTALLATION.) (See REAR SHOCK ABSORBER INSPECTION.) (See REAR SHOCK ABSORBER DISPOSAL.) Rear coil spr

    SEE MORE:

     Oil Control Valve (OCV)

    OIL CONTROL VALVE (OCV) INSPECTION Coil Resistance Inspection 1. Disconnect the negative battery cable. 2. Disconnect the OCV connector. 3. Measure the coil resistance between terminals A and B using a tester. If not within the specification, replace the OCV. (See OIL CONTROL VALVE (OCV) REMOV

     Fuel Pump Unit

    FUEL PUMP UNIT REMOVAL/INSTALLATION WARNING: Fuel is very flammable liquid. If fuel spills or leaks from the pressurized fuel system, it will cause serious injury or death and facility breakage. Fuel can also irritate skin and eyes. To prevent this, always complete the "Fuel Line Safety Proc

    © 2016-2020 Copyright www.m2info.net