Mazda 2: Warning/Indicator Lights

Instrument Cluster varies depending on model and specifi cations.

Warning/Indicator Lights


Warning/Indicator lights will appear in any of the highlighted areas

Warning Lights

These lights turn on or fl ash to notify the user of the system operation status or a system malfunction.

Warning Lights


Warning Lights


*1 The light turns on when the ignition is switched on for an operation check, and turns off a few seconds later or when the engine is started. If the light does not turn on or remains turned on, have the vehicle inspected at an expert repairer, we recommend an Authorised Mazda Repairer.

*2 The light turns on continuously when the parking brake is applied.

Indicator Lights

These lights turn on or fl ash to notify the user of the system operation status or a system malfunction.

Indicator Lights


Indicator Lights


Indicator Lights


*1 The light turns on when the ignition is switched on for an operation check, and turns off a few seconds later or when the engine is started. If the light does not turn on or remains turned on, have the vehicle inspected at an expert repairer, we recommend an Authorised Mazda Repairer.

Wrench Indicator Light

When the ignition is switched
ON, the warning light is illuminated and then turns off after a few seconds.

The wrench indicator light is illuminated when the preset maintenance period arrives. Verify the content and perform maintenance.

Refer to Maintenance Monitor on page 6-15 .

SKYACTIV-D 1.5

The wrench indicator light turns on when the engine oil has deteriorated, is insuffi cient * , is around the X mark on the oil level gauge or reaches a position exceeding the X mark.

Check the engine oil. Refer to Inspecting Engine Oil Level on page 6-28 .

Replace the engine oil if the wrench indicator light does not turn off even though the engine oil level is in the normal range.

NOTE

Low Engine Coolant Temperature Indicator Light (Blue)

The light illuminates
continuously when the engine coolant temperature is low and turns off after the engine is warm.

If the low engine coolant temperature indicator light remains illuminated after the engine has been suffi ciently warmed up, the temperature sensor could have a malfunction. Consult an expert repairer, we recommend an Authorised Mazda Repairer.

Glow Indicator Light (SKYACTIV-D 1.5)

This light may illuminate when
the ignition is switched ON.

It turns off when the glow plugs are warm.

If the ignition is left switched ON for a long period of time without the engine running after the glow plugs are warmed up, the glow plugs may warm up again which will illuminate the glow indicator light.

READ NEXT:

 Transaxle

 Manual Transaxle Operation

Manual Transaxle Shift Pattern The vehicle is equipped with either a 5-speed or 6-speed manual transaxle. The shift pattern for each is shown above. Depress the clutch pedal all the way down

 Automatic Transaxle Controls

Various Lockouts: Indicates that you must depress the brake pedal and hold in the lock-release button to shift (The ignition must be switched ON). Indicates the selector lever can be shifte

SEE MORE:

 Cooling System

COOLING SYSTEM LOCATION INDEX Cooling system cap (See COOLING SYSTEM CAP INSPECTION) Cooling fan motor (See COOLING FAN MOTOR REMOVAL/INSTALLATION) (See COOLING FAN MOTOR INSPECTION) Coolant reserve tank (See ENGINE COOLANT LEVEL INSPECTION) (See COOLANT RESERVE TANK REMOVAL/I

 Hazard Warning Flasher

The hazard warning lights should always be used when you stop on or near a roadway in an emergency. The hazard warning lights warn other drivers that your vehicle is a traffi c hazard and that they must take extreme caution when near it. Depress the hazard warning fl asher and all the d

© 2016-2020 Copyright www.m2info.net