Mazda 2: Towing/Tiedown Hooks

CAUTION

NOTE

When towing with chain or lead, wrap the chain or lead with a soft cloth near the bumper to prevent damage to the bumper.

Towing Hook-Front

  1. Remove the towing eyelet and the wheel brace from the luggage compartment (page 7-3 ).
  2. Wrap a jack lever or similar tool with a soft cloth to prevent damage to a painted bumper, and open the cap located on the front bumper.

Towing Hook-Front


CAUTION

Do not use excessive force as it may damage the cap or scratch the painted bumper surface.

NOTE

Remove the cap completely and store it so as not to lose it.

  1. Securely install the towing eyelet using the wheel brace.

Towing Hook-Front


  1. Hook the towing rope to the towing eyelet.

CAUTION

If the towing eyelet is not securely tightened, it may loosen or disengage from the bumper when towing the vehicle. Make sure that the towing eyelet is securely tightened to the bumper.

Tiedown Hook-Rear

The hook positioned under the rear bumper on the driver's side is for tying down the vehicle during transport, and it cannot be used for towing other vehicles.

It can be used as a towing hook only when the vehicle must be towed by another vehicle in an emergency case such as when the vehicle is stuck in snow, however, it may damage the bumper.

Tiedown Hook-Rear


CAUTION

When using the hook in such emergency cases, observe the following so as not to damage the tiedown hook or the vehicle body.

READ NEXT:

 Warning/Indicator Lights and Warning Sounds

 If a Warning Light Turns On or Flashes

If any warning light turns on/fl ashes, take appropriate action for each light. There is no problem if the light turns off, however if the light does not turn off or turns on/fl ashes again, con

 Message Indicated on Display

If a message is displayed in the centre display (Type C/Type D audio), take appropriate action (in a calm manner) according to the displayed message. Stop Vehicle in Safe Place Immediately If

SEE MORE:

 Wiper Blades

CAUTION Hot waxes applied by automatic car washers have been known to affect the wiper's ability to clean windows. To prevent damage to the wiper blades, do not use petrol, paraffi n, paint thinner, or other solvents on or near them. When the wiper lever is in the AUTO position and the igni

 Magnetic Clutch

MAGNETIC CLUTCH DISASSEMBLY/ASSEMBLY 1. Assemble in the reverse order of disassembly. Bolt Washer Pressure plate Shim Snap ring (1) A/C compressor pulley Snap ring (2) Stator A/C compressor body 2. Assemble in the reverse order of disassembly. 3. Adjust the magnetic clutch clearance. (S

© 2016-2022 Copyright www.m2info.net