Mazda 2: Tire Pressure Monitoring System (TPMS)

Mazda 2 2007-2014 Service Manual / Suspension / Tire Pressure Monitoring System (TPMS)

TIRE PRESSURE MONITORING SYSTEM (TPMS) WIRING DIAGRAM

Mazda 2. TIRE PRESSURE MONITORING SYSTEM (TPMS) WIRING DIAGRAM

TIRE PRESSURE MONITORING SYSTEM (TPMS) ON-BOARD DIAGNOSIS

On-Board Diagnostic (OBD) Test Description

Read/Clear Diagnostic Results

PID/Data Monitor And Record

Reading DTCs Procedure

1. Connect the M-MDS (IDS) to the DLC-2.

2. After the vehicle is identified, select the following items from the initialization screen of the IDS.

  1. Select "Self Test".
  2. Select "Modules".
  3. Select "IC".

3. Verify the DTC according to the directions on the screen.

4. After completion of repairs, clear all DTCs stored in the instrument cluster. (See Clearing DTCs Procedures).

Clearing DTCs Procedures

1. Connect the M-MDS (IDS) to the DLC-2.

2. After the vehicle is identified, select the following items from the initialization screen of the IDS.

  1. Select "Self Test".
  2. Select "Modules".
  3. Select "IC".

3. Verify the DTC according to the directions on the screen.

4. Press the clear button on the DTC screen to clear the DTC.

5. Switch the ignition to off.

6. Switch the ignition to ON and wait for 5 s or more.

7. Perform DTC inspection. (See Reading DTCs Procedure).

8. Verify that no DTCs are displayed.

PID/Data Monitor And Record Procedure

1. Connect the M-MDS (IDS) to the DLC-2.

2. After the vehicle is identified, select the following items from the initialization screen of the IDS.

  1. Select "DataLogger".
  2. Select "Modules".
  3. Select "IC".

3. Select the applicable PID from the PID table. (See PID/Data Monitor Table).

4. Verify the PID data according to the directions on the screen.

NOTE:

DTC Table

Mazda 2. TIRE PRESSURE MONITORING SYSTEM (TPMS) ON-BOARD DIAGNOSIS

Mazda 2. TIRE PRESSURE MONITORING SYSTEM (TPMS) ON-BOARD DIAGNOSIS

PID/Data Monitor Table

NOTE:

READ NEXT:

 Malfunctioning Wheel Unit Identification

NOTE: The tire pressure monitoring system (TPMS) does not identify the location of the malfunctioning wheel unit on the vehicle (RF, LF, LR, RR). The TPMS identifies each wheel unit as No.1, N

 Precaution

Intermittent Concern Troubleshooting Vibration method If malfunction occurs or becomes worse while driving on a rough road or when the engine is vibrating, perform the steps below. NOTE: There are

 Symptom Troubleshooting

NO.1 TPMS WARNING LIGHT ILLUMINATES CONTINUOUSLY CAUTION: The tire pressure cannot be measured accurately after driving for a long period due to the internal temperature and pressure. Stop the v

SEE MORE:

 Brake Fluid

BRAKE FLUID INSPECTION 1. Verify that the brake fluid level in the reserve tank is between the MAX and MIN marks. If the brake fluid level is below the MIN mark, add brake fluid. BRAKE FLUID AIR BLEEDING CAUTION: Keep the fluid level in the reservoir at 3/4 full or more during the air blee

 Jacking Positions, Vehicle Lift (2 Supports) and Safety Stand (Rigid Rack) Positions

Jacking Positions WARNING: Improperly jacking a vehicle is dangerous. The vehicle can slip off the jack and cause serious injury. Use only the correct front and rear jacking points and block the wheels. Use safety stands to support the vehicle after it has been lifted. Front NOTE: To preven

© 2016-2021 Copyright www.m2info.net