Mazda 2: Symptom Troubleshooting [Instrument Cluster]
![Mazda 2. SYMPTOM TROUBLESHOOTING [INSTRUMENT CLUSTER]](images/books/1059/mazda_2_symptom_troubleshooting_instrument_cluster__3005.jpg)
QUICK DIAGNOSTIC CHART [INSTRUMENT CLUSTER]
![Mazda 2. QUICK DIAGNOSTIC CHART [INSTRUMENT CLUSTER]](images/books/1059/mazda_2_symptom_troubleshooting_instrument_cluster__3006.gif)
NO. 1 FUEL GAUGE INDICATOR LIGHT INDICATION IS INCORRECT

Diagnostic procedure


NO. 2 ALL METERS AND GAUGES DO NOT OPERATE

Diagnostic procedure


NO. 3 ABS WARNING LIGHT ILLUMINATES

Diagnostic procedure



NO. 4 MIL ILLUMINATES

Diagnostic procedure



NO. 5 BRAKE SYSTEM WARNING LIGHT ILLUMINATES

Diagnostic procedure




NO. 6 INSTRUMENT CLUSTER ILLUMINATION DOES NOT ILLUMINATE

Diagnostic procedure


NO. 7 SPEEDOMETER INDICATION IS DEFECTIVE

Diagnostic procedure



NO. 8 TACHOMETER INDICATION IS DEFECTIVE

Diagnostic procedure



NO. 9 LOW ENGINE COOLANT TEMPERATURE INDICATOR LIGHT/HIGH ENGINE
COOLANT
TEMPERATURE WARNING LIGHT ILLUMINATES OR FLASHES CONTINUOUSLY

Diagnostic procedure



NO. 10 MALFUNCTION WARNING LIGHT ILLUMINATES

Diagnostic procedure



READ NEXT:
NOTE:
Note down all radio programs set by the customer prior to the repairs.
Reset all radio programs and adjust the time
after the repairs.
Troubleshooting Index
Quick Diagnostic Chart (Entire
NOTE:
If the location, time, and broadcasting station etc. can be specified
through interview with the customer, there is the possibility
that the signal reception environment is the cause of the
1. Multipath Noise
Signals from an FM transmitter are a high frequency and similar to beams
of light
because they do not bend around corners, but they do reflect. Since FM
signals can be
refle
SEE MORE:
OIL SEAL REPLACEMENT
CAUTION:
The oil seal is easily damaged by the sharp edges of the drive shaft
splines. Do not let
the splines contact the oil seal.
1. Drain the ATF into a separate suitable container. (See AUTOMATIC TRANSAXLE
FLUID (ATF) REPLACEMENT).
2. Remove the drive shaft and/or jo
CONDENSER REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Collect the refrigerant. (See REFRIGERANT CHARGING).
3. Drain the engine coolant. (See ENGINE COOLANT REPLACEMENT] ).
4. Remove the following parts:
Front bumper (See FRONT BUMPER REMOVAL/INSTALLATION).
Seal board uppe
© 2016-2022 Copyright www.m2info.net
