Mazda 2: Symptom Troubleshooting

Mazda 2 2007-2014 Service Manual / Restraints / Symptom Troubleshooting

Troubleshooting Index

Mazda 2. SYMPTOM TROUBLESHOOTING

AIR BAG SYSTEM WIRING DIAGRAM (SYMPTOM TROUBLESHOOTING)

Mazda 2. AIR BAG SYSTEM WIRING DIAGRAM (SYMPTOM TROUBLESHOOTING)

Mazda 2. SYMPTOM TROUBLESHOOTING

NO.1 AIR BAG SYSTEM WARNING LIGHT DOES NOT ILLUMINATE

Mazda 2. SYMPTOM TROUBLESHOOTING

Diagnostic Procedure

Mazda 2. SYMPTOM TROUBLESHOOTING

Mazda 2. SYMPTOM TROUBLESHOOTING

Mazda 2. SYMPTOM TROUBLESHOOTING

NO.2 AIR BAG SYSTEM WARNING LIGHT IS ILLUMINATED ALL THE TIME

Mazda 2. SYMPTOM TROUBLESHOOTING

System Wiring Diagram

Mazda 2. SYMPTOM TROUBLESHOOTING

Diagnostic Procedure

Mazda 2. SYMPTOM TROUBLESHOOTING

Mazda 2. SYMPTOM TROUBLESHOOTING

Mazda 2. SYMPTOM TROUBLESHOOTING

READ NEXT:

 Location Index

Curtain air bag module (See CURTAIN AIR BAG MODULE REMOVAL/INSTALLATION.) (See AIR BAG MODULE AND PRE-TENSIONER SEAT BELT DEPLOYMENT PROCEDURES.) Driver-side air bag module (See DRIVE

 Driver/Passenger-side Air Bag Module

DRIVER-SIDE AIR BAG MODULE REMOVAL/INSTALLATION WARNING: Handling the air bag module improperly can accidentally deploy the air bag module, which may seriously injure you. Read the air bag system

 Side Air Bag Module

SIDE AIR BAG MODULE REMOVAL/INSTALLATION WARNING: Handling the air bag module improperly can accidentally operate (deploy) the air bag module, which may seriously injure you. Read the air bag sys

SEE MORE:

 DTC B1129:11/B1129:12/B1129:13/B1129:19/B1129:1A

System Malfunction Location Detection Condition WARNING: Detection conditions are for understanding the DTC outline before performing an inspection. Performing an inspection according to only the detection conditions may cause injury due to an operating error, or damage the system. When p

 Oil Control Valve (OCV)

OIL CONTROL VALVE (OCV) INSPECTION Coil Resistance Inspection 1. Disconnect the negative battery cable. 2. Disconnect the OCV connector. 3. Measure the coil resistance between terminals A and B using a tester. If not within the specification, replace the OCV. (See OIL CONTROL VALVE (OCV) REMOV

© 2016-2021 Copyright www.m2info.net