Mazda 2: Symptom Troubleshooting

Mazda 2 2007-2014 Service Manual / Brakes / Symptom Troubleshooting

Mazda 2. SYMPTOM TROUBLESHOOTING

*1 DSC system function contains traction control function, DSC indicator light goes on and out while DSC operates
*2 DSC indicator light goes on and out while DSC operates

Mazda 2. SYMPTOM TROUBLESHOOTING

NO.1 ANY OF THE FOLLOWING LIGHTS DO NOT ILLUMINATE WITH SWITCH THE IGNITION TO ON: (ABS WARNING LIGHT, BRAKE SYSTEM WARNING LIGHT, DSC INDICATOR LIGHT AND/OR DSC OFF LIGHT)

Mazda 2. SYMPTOM TROUBLESHOOTING

Diagnostic procedure

Mazda 2. SYMPTOM TROUBLESHOOTING

Mazda 2. SYMPTOM TROUBLESHOOTING

NO.2 ANY OF THE FOLLOWING LIGHTS REMAIN ON: (ABS WARNING LIGHT, BRAKE SYSTEM WARNING LIGHT, DSC INDICATOR LIGHT AND/OR DSC OFF LIGHT)

Mazda 2. SYMPTOM TROUBLESHOOTING

Diagnostic procedure

Mazda 2. SYMPTOM TROUBLESHOOTING

Mazda 2. SYMPTOM TROUBLESHOOTING

Mazda 2. SYMPTOM TROUBLESHOOTING

NO.3 THERE IS A MALFUNCTION IN THE SYSTEM EVEN THOUGH ABS WARNING LIGHT, BRAKE SYSTEM WARNING LIGHT, DSC INDICATOR LIGHT AND DSC OFF LIGHT DO NOT ILLUMINATE

Mazda 2. SYMPTOM TROUBLESHOOTING

Diagnostic procedure

Mazda 2. SYMPTOM TROUBLESHOOTING

NO.4 ABS OR TCS*1 OPERATES FREQUENTLY/TCS DOES NOT WORK CORRECTLY *1: DSC SYSTEM FUNCTION CONTAINS TRACTION CONTROL FUNCTION, DSC INDICATOR LIGHT GOES ON AND OUT WHILE DSC OPERATES

Mazda 2. SYMPTOM TROUBLESHOOTING

Diagnostic procedure

Mazda 2. SYMPTOM TROUBLESHOOTING

Mazda 2. SYMPTOM TROUBLESHOOTING

NO.5 DSC*2 OPERATES FREQUENTLY/DSC DOES NOT WORK CORRECTLY *2: DSC INDICATOR LIGHT GOES ON AND OUT WHILE DSC OPERATES

Mazda 2. SYMPTOM TROUBLESHOOTING

Diagnostic procedure

Mazda 2. SYMPTOM TROUBLESHOOTING

Mazda 2. SYMPTOM TROUBLESHOOTING

READ NEXT:

 General Procedures

Wheel and Tire Installation 1. When installing the wheels and tires, tighten the wheel nuts in a criss-cross pattern to the following tightening torque. Tightening torque 88-118 N*m {9.0-12 Kgf*

 Conventional Brake System

CONVENTIONAL BRAKE SYSTEM LOCATION INDEX Vacuum line (See VACUUM LINE INSPECTION.) (See VACUUM HOSE REMOVAL/INSTALLATION.) Brake fluid (See BRAKE FLUID INSPECTION.) (See BRAKE FLUID A

 Brake Fluid

BRAKE FLUID INSPECTION 1. Verify that the brake fluid level in the reserve tank is between the MAX and MIN marks. If the brake fluid level is below the MIN mark, add brake fluid. BRAKE FLUID AIR

SEE MORE:

 Before/After Service

BEFORE SERVICE PRECAUTION WARNING: Fuel vapor is hazardous. It can very easily ignite, causing serious injury and damage. Always keep sparks and flames away from fuel. Fuel line spills and leakage from the pressurized fuel system are dangerous. Fuel can ignite and cause serious injury or d

 Front Door Key Cylinder

FRONT DOOR KEY CYLINDER REMOVAL/INSTALLATION 1. To access the glass installation bolt, position the front door glass so that the distance from the top of the front door glass to the upper part of the front beltline molding is approx. 110 mm {4.33 in}. 2. Disconnect the negative battery cable. 3

© 2016-2021 Copyright www.m2info.net