Mazda 2: Symptom Troubleshooting

Mazda 2 2007-2014 Service Manual / Suspension / Symptom Troubleshooting

Mazda 2. SYMPTOM TROUBLESHOOTING

NO.1 TPMS WARNING LIGHT ILLUMINATES CONTINUOUSLY

CAUTION:

NOTE:

Mazda 2. SYMPTOM TROUBLESHOOTING

Diagnostic Procedure

Mazda 2. SYMPTOM TROUBLESHOOTING

Mazda 2. SYMPTOM TROUBLESHOOTING

NO.2 TPMS WARNING LIGHT (LOW PRESSURE WARNING) ILLUMINATES AFTER ENGINE START AND TURNS OFF AFTER DRIVING FOR PERIOD OF TIME

CAUTION:

NOTE:

Mazda 2. SYMPTOM TROUBLESHOOTING

Diagnostic Procedure

Mazda 2. SYMPTOM TROUBLESHOOTING

Mazda 2. SYMPTOM TROUBLESHOOTING

NO.3 WHEEL UNIT ID REGISTRATION CANNOT BE PERFORMED (TPMS WARNING LIGHT FLASHES)

CAUTION:

Mazda 2. SYMPTOM TROUBLESHOOTING

Diagnostic Procedure

Mazda 2. SYMPTOM TROUBLESHOOTING

Mazda 2. SYMPTOM TROUBLESHOOTING

READ NEXT:

 General Procedures

Wheel And Tire Removal/Installation 1. When installing the wheels and tires, tighten the wheel nuts in a criss-cross pattern to the following tightening torque. Tightening Torque 88-118 N*m {9.

 Wheel Alignment Pre-inspection

1. Park the vehicle on a level ground, in an unloaded condition*, and with the wheels straight forward. *: Unloaded condition.....Fuel tank is full. Engine coolant and engine oil are at specified l

 Wheel and Tire Specification

Standard tire *3 Verify the tire label attached to the actual vehicle on vehicles without TPMS. Spare tire WHEEL BALANCE ADJUSTMENT (ALUMINUM ALLOY WHEEL) CAUTION: Adjust the outer wheel balance

SEE MORE:

 Operational Range

The system operates only when the driver is in the vehicle or within operational range while the key is being carried. NOTE When the battery power is low, or in places where there are high-intensity radio waves or noise, the operational range may become narrower or the system may not operate

 Magnetic Clutch

MAGNETIC CLUTCH DISASSEMBLY/ASSEMBLY 1. Assemble in the reverse order of disassembly. Bolt Washer Pressure plate Shim Snap ring (1) A/C compressor pulley Snap ring (2) Stator A/C compressor body 2. Assemble in the reverse order of disassembly. 3. Adjust the magnetic clutch clearance. (S

© 2016-2021 Copyright www.m2info.net