Mazda 2: Suspension
Mazda 2 2007-2014 Service Manual / Suspension
- Tire Pressure Monitoring System (TPMS)
- Malfunctioning Wheel Unit Identification
- Precaution
- Symptom Troubleshooting
- General Procedures
- Wheel Alignment Pre-inspection
- Wheel and Tire Specification
- Wheel Unit ID Registration
- Front Suspension
- Rear Suspension
READ NEXT:
Tire Pressure Monitoring System (TPMS)
TIRE PRESSURE MONITORING SYSTEM (TPMS) WIRING DIAGRAM
TIRE PRESSURE MONITORING SYSTEM (TPMS) ON-BOARD DIAGNOSIS
On-Board Diagnostic (OBD) Test Description
The OBD test inspects the integrity and fu
Malfunctioning Wheel Unit Identification
NOTE:
The tire pressure monitoring system (TPMS) does not identify the
location of the
malfunctioning wheel unit on the vehicle (RF, LF, LR, RR). The TPMS
identifies each
wheel unit as No.1, N
Precaution
Intermittent Concern Troubleshooting
Vibration method
If malfunction occurs or becomes worse while driving on a rough road or when
the
engine is vibrating, perform the steps below.
NOTE:
There are
SEE MORE:
Mechanical System Test
Mechanical System Test Preparation
1. Engage the parking brake and use wheel chocks at the front and rear of the
wheels.
2. Inspect the engine coolant. (See ENGINE COOLANT LEVEL INSPECTION).
3. Inspect the engine oil. (See ENGINE OIL LEVEL INSPECTION).
4. Inspect the ATF. (See AUTOMATIC TRANSAXL
Condenser
CONDENSER REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Collect the refrigerant. (See REFRIGERANT CHARGING).
3. Drain the engine coolant. (See ENGINE COOLANT REPLACEMENT] ).
4. Remove the following parts:
Front bumper (See FRONT BUMPER REMOVAL/INSTALLATION).
Seal board uppe
© 2016-2021 Copyright www.m2info.net