Mazda 2: Steering Wheel

WARNING

Never adjust the steering wheel while the vehicle is moving: Adjusting the steering wheel while the vehicle is moving is dangerous. Moving it can very easily cause the driver to abruptly turn to the left or right.

This can lead to loss of control or an accident.

Steering Wheel Adjustment

To change the angle or length of the steering wheel:

  1. Stop the vehicle, and then pull down the lock release lever under the steering column.

Steering Wheel Adjustment


  1. Tilt the steering wheel and/or adjust the steering column length to the desired positions, then push the lever up to lock the column.
  2. Attempt to push the steering wheel up and down to make sure it's locked before driving.

NOTE

Make sure that the steering wheel is locked fi rmly in place. If it is diffi cult to raise the lever, lightly move the steering wheel forward and back to pull up the lever.

READ NEXT:

 Mirrors

Before driving, adjust the inside and outside mirrors. Outside Mirrors WARNING Be sure to look over your shoulder before changing lanes: Changing lanes without taking into account the actual di

 Windows

Power Windows The ignition must be switched ON for the power windows to operate. WARNING Make sure the opening is clear before closing a window: Closing a power window is dangerous. A person'

 Security System

SEE MORE:

 Immobilizer System

The immobilizer system allows the engine to start only with a key the system recognises. If someone attempts to start the engine with an unrecognised key, the engine will not start, thereby helping to prevent vehicle theft. If you have a problem with the immobilizer system or the key, co

 Manifold Absolute Pressure (MAP) Sensor

MANIFOLD ABSOLUTE PRESSURE (MAP) SENSOR REMOVAL/INSTALLATION 1. Disconnect the negative battery cable. 2. Remove the fresh-air duct and the air cleaner as a single unit. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION). 3. Disconnect the MAP sensor connector. 4. Remove the MAP sensor 5. Install in

© 2016-2020 Copyright www.m2info.net