Mazda 2: Side Air Bag Module
SIDE AIR BAG MODULE REMOVAL/INSTALLATION
WARNING:
1. Switch the ignition to off.
2. Disconnect the negative battery cable and wait for 1 min or more.
3. Remove the front seat. (See FRONT SEAT REMOVAL/INSTALLATION).
4. Remove the front seat back trim and pad. (See FRONT SEAT BACK COMPONENT
REMOVAL/INSTALLATION).
5. Remove the band securing the side air bag module wiring harness. (See Band
Installation
Note)

6. Remove the nuts.

7. Remove the side air bag module.
8. Install in the reverse order of removal.
9. Switch the ignition to ON.
10. Verify that the air bag system warning light illuminates for approx. 6 s and
goes out.
- If the air bag system warning light does not operate normally, refer to
the
on-board diagnostic system (air bag system) and perform inspection of the
system. (See FLOWCHART).
Band Installation Note
1. Install the band with the end pointed to the front.

2. Cut off the end of the band at the position shown in the figure.
READ NEXT:
CURTAIN AIR BAG MODULE REMOVAL/INSTALLATION
WARNING:
Handling the air bag module improperly can accidentally deploy the air
bag module, which may seriously injure you. Read the air
bag system ser
CRASH ZONE SENSOR REMOVAL/INSTALLATION
WARNING:
Handling the crash zone sensor improperly can accidentally deploy the
air bags and
pre-tensioner seat belts, which may seriously injure you. Read t
SAS CONTROL MODULE REMOVAL/INSTALLATION
WARNING:
Handling the SAS control module improperly can accidentally deploy the
air bag modules and
pre-tensioner seat belt, which may seriously injure you
SEE MORE:
Verify the symptoms, and perform troubleshooting according to the
appropriate number.
*1 DSC system function contains traction control function, DSC indicator
light goes on and out while DSC operates
*2 DSC indicator light goes on and out while DSC operates
NO.1 ANY OF THE FOLLOWING LIGHTS
AIR INTAKE DUCT REMOVAL/INSTALLATION
1. Set the air intake mode to REC.
2. Disconnect the negative battery cable.
3. Remove the following parts:
Glove compartment (See GLOVE COMPARTMENT REMOVAL/INSTALLATION).
Dashboard under cover (See DASHBOARD UNDER COVER
REMOVAL/INSTALLATION).
Heat duct (R
© 2016-2022 Copyright www.m2info.net
