Mazda 2: Saving Fuel and Protection of the Environment
Mazda2 DJ 2014–2021 Owners Manual / Before Driving / Driving Tips / Saving Fuel and Protection of the Environment
How you operate your Mazda determines how far it will travel on a tank of fuel. Use these suggestions to help save fuel and reduce CO2.
- Avoid long warm-ups. Once the engine runs smoothly, begin driving.
- Avoid fast starts
- Drive at lower speeds.
- Anticipate when to apply the brakes (avoid sudden braking).
- Follow the maintenance schedule (page 6-3 ) and have an expert repairer, we recommend an Authorised Mazda Repairer perform inspections and servicing.
- Use the air conditioner only when necessary.
- Slow down on rough roads.
- Keep the tyres properly infl ated.
- Do not carry unnecessary weight.
- Do not rest your foot on the brake pedal while driving.
- Keep the wheels in correct alignment.
- Keep windows closed at high speeds
- Slow down when driving in crosswinds and headwinds.
WARNING
Never stop the engine when going down a hill: Stopping the engine when going down a hill is dangerous. This causes the loss of power steering and power brake control, and may cause damage to the drivetrain. Any loss of steering or braking control could cause an accident.
READ NEXT:
Hazardous Driving
WARNING
Be extremely careful if it is necessary
to downshift on slippery surfaces:
Downshifting into lower gear while
driving on slippery surfaces is
dangerous. The sudden change in tyre
speed c
Floor Mat
WARNING
Make sure the fl oor mats are secured
with the grommets or the retainers to
prevent them from bunching up under
the foot pedals (Driver's side):
Using a fl oor mat that is not secured is
Rocking the Vehicle
WARNING
Do not spin the wheels at high speed,
and do not allow anyone to stand
behind a wheel when pushing the
vehicle:
When the vehicle is stuck, spinning
the wheels at high speed is dangerous.
SEE MORE:
Brake Hose (Front)
BRAKE HOSE (FRONT) REMOVAL/INSTALLATION
1. Remove in the order indicated in the table.
2. Install in the reverse order of removal.
3. Add brake fluid, bleed the brakes, and inspect for leakage after the
installation has been completed. (See
BRAKE FLUID AIR BLEEDING).
Bolt
Bolt
Brake pipe
C
Manual Type
Type A
Type B
Type C
Type D
Control Switches
Temperature control dial
(Type A/Type B/Type C)
This dial controls temperature. Turn it
clockwise for hot and anticlockwise for
cold.
(Type D)
This dial controls the air temperature when
using the air conditioner. Turn it clockwise
© 2016-2021 Copyright www.m2info.net