Mazda 2: Rocking the Vehicle

WARNING

Do not spin the wheels at high speed, and do not allow anyone to stand behind a wheel when pushing the vehicle: When the vehicle is stuck, spinning the wheels at high speed is dangerous.

The spinning tyre could overheat and explode. This could cause serious injuries.

CAUTION

Too much rocking may cause engine overheating, transaxle failure, and tyre damage.

If you must rock the vehicle to free it from snow, sand or mud, depress the accelerator slightly and slowly move the shift lever from 1 (D) to R.

READ NEXT:

 Winter Driving

Carry emergency gear, including tyre chains, window scraper, fl ares, a small shovel, jumper leads, and a small bag of sand or salt. Ask an expert repairer, we recommend an Authorised Mazda Rep

 Driving In Flooded Area

WARNING Dry off brakes that have become wet by driving slowly, releasing the accelerator pedal and lightly applying the brakes several times until the brake performance returns to normal: Drivin

 Turbocharger Information (SKYACTIV-D 1.5)

CAUTION After driving at freeway speeds or up a long hill, idle the engine at least 30 seconds before stopping it. Otherwise, the turbocharger could be damaged. However, when i-stop oper

SEE MORE:

 Brake Pedal

BRAKE PEDAL INSPECTION Pedal Height Inspection 1. Measure the distance from the steering shaft cover to the center of the upper surface of the pedal pad and verify that it is as specified. If not within the specification, replace the pedal component. Pedal height (reference value) 192 mm

 PID/DATA Monitor

PID/DATA MONITOR DISPLAY 1. Connect the M-MDS(IDS) to the DLC-2. 2. After the vehicle is identified, select the following items from the initialization screen of the IDS. Select "DataLogger". Select "Modules". Select "RCM". 3. Select the applicable PID from the PID table. 4. Verify the PID d

© 2016-2022 Copyright www.m2info.net