Mazda 2: Refrigerant System Service
REFRIGERANT SYSTEM SERVICE WARNINGS
Handling Refrigerant
Storing Refrigerant
- The refrigerant container is highly pressurized. If it is subjected
to high heat,
it could explode, scattering metal fragments and liquid refrigerant that can
seriously injure you. Store the refrigerant at temperatures below 40
READ NEXT:
CAUTION:
Do not exceed the specification when charging the system with
refrigerant. Doing so
will decrease the efficiency of the air conditioner or damage the
refrigeration cycle
parts.
Charg
HVAC BASIC SYSTEM LOCATION INDEX
Refrigerant lines
(See REFRIGERANT LINE REMOVAL/INSTALLATION.)
Air intake duct
(See AIR INTAKE DUCT REMOVAL/INSTALLATION.)
(See AIR INTAKE DUCT DISASSEMB
A/C UNIT REMOVAL/INSTALLATION
1. Set the air intake mode to REC.
2. Disconnect the negative battery cable.
3. Collect the refrigerant. (See REFRIGERANT CHARGING).
4. Drain the engine coolant. (See
SEE MORE:
A/C COMPRESSOR REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Remove the splash shield (RH).
3. Collect the refrigerant. (See REFRIGERANT CHARGING).
4. Remove the drive belt. (See DRIVE BELT REMOVAL/INSTALLATION] ).
5. Remove the clip retaining the compressor wiring harness to
GENERAL PROCEDURES (FRONT AND REAR AXLES)
Wheel and Tire Installation
1. When installing the wheels and tires, tighten the wheel nuts in a criss-cross
pattern to the
following tightening torque.
Tightening Torque
88-118 N*m {9.0-12 kgf*m, 65-87 ft*lbf}
Connector Disconnection
1. Disconnect t
© 2016-2021 Copyright www.m2info.net