Mazda 2: Rear Window Defogger

The rear window defogger clears fog from the rear window.

The ignition must be switched ON to use the defogger.

Press the switch to turn on the rear window defogger. The rear window defogger operates for about 15 minutes and then turns off automatically.

The indicator light illuminates when the defogger is operating.

To turn off the rear window defogger before the 15 minutes has elapsed, press the switch again.

Manual Air-Conditioning

Manual Air-Conditioning


Fully Automatic Air-Conditioning

Fully Automatic Air-Conditioning


CAUTION

Do not use sharp instruments or window cleaners with abrasives to clean the inside of the rear window surface. They may damage the defogger grid inside the window.

NOTE

This defogger is not designed for melting snow. If there is an accumulation of snow on the rear window, remove it before using the defogger.

Mirror Defogger *

To turn on the mirror defoggers, switch the ignition ON and press the rear window defogger switch (page 4-74 ).

Horn

To sound the horn, press the
mark on the steering wheel.

READ NEXT:

 Hazard Warning Flasher

The hazard warning lights should always be used when you stop on or near a roadway in an emergency. The hazard warning lights warn other drivers that your vehicle is a traffi c hazard and tha

 Brake

 Brake System

Foot Brake This vehicle has power-assisted brakes that adjust automatically through normal use. Should power-assist fail, you can stop by applying greater force than normal to the brake pedal.

SEE MORE:

 Ignition System

IGNITION SYSTEM LOCATION INDEX Ignition coil (See IGNITION COIL REMOVAL/INSTALLATION) (See IGNITION COIL INSPECTION) Spark plug (See SPARK PLUG REMOVAL/INSTALLATION) (See SPARK PLUG INSPECTION) IGNITION COIL REMOVAL/INSTALLATION 1. Disconnect the negative battery cable. CAUTION:

 DTC B1129:11/B1129:12/B1129:13/B1129:19/B1129:1A

System Malfunction Location Detection Condition WARNING: Detection conditions are for understanding the DTC outline before performing an inspection. Performing an inspection according to only the detection conditions may cause injury due to an operating error, or damage the system. When p

© 2016-2021 Copyright www.m2info.net