Mazda 2: Rear Door Trim

REAR DOOR TRIM REMOVAL/INSTALLATION

1. Disconnect the negative battery cable.

2. Remove the sail inner garnish. (See SAIL INNER GARNISH REMOVAL/INSTALLATION) 3. Pull the cover of inner handle while remove the tabs.

4. Remove the screw.

5. Pull in the direction of the arrow shown in the figure and remove clips A from the door inner panel using a fastener remover.

6. Remove the rear door trim in the direction of the arrow shown in the figure.

7. Remove the inner handle and move the rear door trim in the direction of the arrow shown in the figure.

8. Turn the inner handle 90

READ NEXT:

 Lighting Systems

LIGHTING SYSTEMS LOCATION INDEX Back-up light switch Front combination light Auto light sensor Side turn light Front fog light Cargo compartment light Rear combination light High-mount brak

 Wiper/Washer System

WIPER/WASHER SYSTEM LOCATION INDEX Windshield wiper motor Windshield wiper arm and blade Wiper and washer switch Rain sensor Windshield washer hose Rear washer hose Rear washer nozzle Rear w

 Entertainment Location

ENTERTAINMENT LOCATION INDEX Center roof antenna Rear door speaker Audio control switch Tweeter Antenna feeder No.2 Antenna feeder No.1 Center panel unit Front door speaker Auxiliary jack/U

SEE MORE:

 Rear Door Latch and Lock Actuator

REAR DOOR LATCH AND LOCK ACTUATOR REMOVAL/INSTALLATION 1. To access the glass installation bolt, position the rear door glass so that the distance from the top of the rear door glass to the upper part of the rear beltline molding is approx. 210 mm {8.27 in}. 2. Disconnect the negative battery ca

 Overheating

If the High engine coolant temperature warning light illuminates, the vehicle loses power, or you hear a loud knocking or pinging noise, the engine is probably too hot. WARNING Switch the ignition to off and make sure the fan is not running before attempting to work near the cooling fan:

© 2016-2021 Copyright www.m2info.net