Mazda 2: Precaution

Intermittent Concern Troubleshooting

Vibration method

If malfunction occurs or becomes worse while driving on a rough road or when the engine is vibrating, perform the steps below.

NOTE:

Inspection method for switch and/or sensor connectors or wires

1. Connect the M-MDS (IDS) to the DLC-2.

2. Switch the ignition to ON (engine off).

NOTE:

3. Access the PIDs for the switch you are inspecting.

4. Turn switch on manually.

5. Shake each connector or wire harness a bit vertically and horizontally while monitoring the PID.

Mazda 2. PRECAUTION

Inspection method for sensors

1. Connect the M-MDS (IDS) to the DLC-2.

2. Switch the ignition to ON (engine off).

NOTE:

3. Access the PIDs for the switch you are inspecting.

4. Vibrate the sensor slightly with your finger.

Connector terminal check method

1. Check the connection condition of each female terminal.

2. Insert male terminal; fit the female terminal side to female terminal and check to see whether the malfunction is in the female terminal or not.

Mazda 2. PRECAUTION

READ NEXT:

 Symptom Troubleshooting

NO.1 TPMS WARNING LIGHT ILLUMINATES CONTINUOUSLY CAUTION: The tire pressure cannot be measured accurately after driving for a long period due to the internal temperature and pressure. Stop the v

 General Procedures

Wheel And Tire Removal/Installation 1. When installing the wheels and tires, tighten the wheel nuts in a criss-cross pattern to the following tightening torque. Tightening Torque 88-118 N*m {9.

 Wheel Alignment Pre-inspection

1. Park the vehicle on a level ground, in an unloaded condition*, and with the wheels straight forward. *: Unloaded condition.....Fuel tank is full. Engine coolant and engine oil are at specified l

SEE MORE:

 Condenser

CONDENSER REMOVAL/INSTALLATION 1. Disconnect the negative battery cable. 2. Collect the refrigerant. (See REFRIGERANT CHARGING). 3. Drain the engine coolant. (See ENGINE COOLANT REPLACEMENT] ). 4. Remove the following parts: Front bumper (See FRONT BUMPER REMOVAL/INSTALLATION). Seal board uppe

 Symptom Troubleshooting

NO.1 TPMS WARNING LIGHT ILLUMINATES CONTINUOUSLY CAUTION: The tire pressure cannot be measured accurately after driving for a long period due to the internal temperature and pressure. Stop the vehicle for approx. 1 hour and then perform the tire pressure measurement and adjustment. Use a h

© 2016-2021 Copyright www.m2info.net