Mazda 2: PID/DATA Monitor
Mazda 2 2007-2014 Service Manual / Restraints / PID/DATA Monitor
PID/DATA MONITOR DISPLAY
1. Connect the M-MDS(IDS) to the DLC-2.
2. After the vehicle is identified, select the following items from the initialization screen of the IDS.
- Select "DataLogger".
- Select "Modules".
- Select "RCM".
3. Select the applicable PID from the PID table.
4. Verify the PID data according to the directions on the screen.
NOTE:
- The PID data screen function is used for monitoring the calculated value of input/output signals in the module. Therefore, if the monitored value of the output parts is not within the specification, it is necessary to inspect the monitored value of input parts corresponding to the applicable output part control. In addition, because the system does not display an output part malfunction as an abnormality in the monitored value, it is necessary to inspect the output parts individually.
PID/DATA MONITOR TABLE
READ NEXT:
Symptom Troubleshooting
Troubleshooting Index
Use the chart below to verify the symptoms of the trouble in order to
diagnose the
appropriate area.
AIR BAG SYSTEM WIRING DIAGRAM (SYMPTOM TROUBLESHOOTING)
NO.1 AIR BAG
Location Index
Curtain air bag module
(See CURTAIN AIR BAG MODULE REMOVAL/INSTALLATION.)
(See AIR BAG MODULE AND PRE-TENSIONER SEAT BELT DEPLOYMENT
PROCEDURES.)
Driver-side air bag module
(See DRIVE
Driver/Passenger-side Air Bag Module
DRIVER-SIDE AIR BAG MODULE REMOVAL/INSTALLATION
WARNING:
Handling the air bag module improperly can accidentally deploy the air
bag module, which may seriously injure you. Read the air
bag system
SEE MORE:
Diesel Particulate Filter (SKYACTIV-D 1.5)
The diesel particulate fi lter collects and
removes most of the particulate matter
(PM) in the exhaust gas of a diesel engine.
PM collected by the diesel particulate
fi lter is cleared during normal driving,
however, PM may not be removed and the
diesel particulate fi lter indicator light ma
Charcoal Canister
CHARCOAL CANISTER REMOVAL/INSTALLATION
CAUTION:
Disconnecting/connecting the quick release connector without cleaning it
may cause
damage to the fuel pipe and quick release connector. Always clean the quick
release
connector joint area before disconnecting/connecting using a cloth or soft
© 2016-2022 Copyright www.m2info.net
