Mazda 2: ON-Board Diagnostic Wiring Diagram [BCM]
![Mazda 2. ON-BOARD DIAGNOSTIC WIRING DIAGRAM [BCM]](images/books/1059/mazda_2_on_board_diagnostic_wiring_diagram_bcm__2799.gif)
![Mazda 2. ON-BOARD DIAGNOSTIC WIRING DIAGRAM [BCM]](images/books/1059/mazda_2_on_board_diagnostic_wiring_diagram_bcm__2800.gif)
![Mazda 2. ON-BOARD DIAGNOSTIC WIRING DIAGRAM [BCM]](images/books/1059/mazda_2_on_board_diagnostic_wiring_diagram_bcm__2801.gif)
DTC INSPECTION [BCM]
1. Connect the M-MDS (IDS) to the DLC-2.
2. Verify the following vehicle conditions:
- Switch the ignition to ON.
- All the switches are turned off (except the ignition switch).
- All the doors, hood, liftgate are closed.
- All the doors, liftgate are unlocked.
- All the seat belts are unbuckled.
- Parking brake lever is pulled.
3. After the vehicle is identified, select the following items from the
initialization screen of
the IDS.
- Select "Self Test".
- Select "Modules".
- Select "BCM/GEM".
4. Verify the DTC according to the directions on the screen.
- If any DTCs are displayed, perform troubleshooting according to the
corresponding DTC inspection.
5. After completion of repairs, clear all DTCs stored in the BCM. (See
CLEARING DTC [BCM] ).
CLEARING DTC [BCM]
1. Connect the M-MDS (IDS) to the DLC-2.
2. After the vehicle is identified, select the following items from the
initialization screen of
the IDS.
- Select "Self Test".
- Select "Modules".
- Select "BCM/GEM".
3. Verify the DTC according to the directions on the screen.
4. Press the clear button on the DTC screen to clear the DTC.
5. Switch the ignition to off.
6. Switch the ignition to ON and wait for 5 s or more.
7. Perform DTC inspection. (See DTC INSPECTION [BCM] ).
8. Verify that no DTCs are displayed.
READ NEXT:
*1 ATX
DTC B1B55:96
Diagnostic procedure
DTC B1C53:13
System Wiring Diagram
Diagnostic Procedure
DTC B1D06:11
System Wiring Diagram
Diagnostic Procedure
DTC B1D06:15
System Wiring Dia
NOTE:
All DTCs displayed in the on-board diagnostic test mode should be
entered in the Audio
Repair Order Form.
1. Turn the ignition switch to the ACC or ON position.
2. Turn the center panel u
NOTE:
"iPod" is a registered trademark of Apple Inc. in the United States and other
countries.
DTC: 28:Er01, 28:Er09
NOTE:
"iPod" is a registered trademark of Apple Inc. in the United States and
SEE MORE:
The rear view monitor provides visual images of the rear of the vehicle when
reversing.
WARNING
Always drive carefully confi rming the safety of the rear and the
surrounding conditions
by looking directly with your eyes:
Reversing the vehicle by only looking at the screen is dangerous as it
System Malfunction Location
Detection Condition
WARNING:
Detection conditions are for understanding the DTC outline before
performing an
inspection. Performing an inspection according to only the detection
conditions may
cause injury due to an operating error, or damage the system. When
p
© 2016-2021 Copyright www.m2info.net