Mazda 2: Neutral Switch

NEUTRAL SWITCH INSPECTION

1. Disconnect the negative battery cable.

2. Remove the neutral switch. (See NEUTRAL SWITCH REMOVAL/INSTALLATION).

3. Inspect for continuity between the neutral switch terminals using an ohmmeter.

Mazda 2. NEUTRAL SWITCH INSPECTION

Specification

Mazda 2. NEUTRAL SWITCH INSPECTION

CLUTCH PEDAL POSITION (CPP) SWITCH INSPECTION

1. Verify that the CPP switch is installed properly.

2. Disconnect the negative battery cable.

3. Disconnect the CPP switch connector. (See CLUTCH PEDAL REMOVAL/INSTALLATION).

4. Inspect for continuity between the CPP switch terminals using an ohmmeter.

Mazda 2. CLUTCH PEDAL POSITION (CPP) SWITCH INSPECTION

Specification

Mazda 2. CLUTCH PEDAL POSITION (CPP) SWITCH INSPECTION

VARIABLE TUMBLE SHUTTER VALVE POSITION SENSOR REMOVAL/INSTALLATION

CAUTION:

1. Remove the variable tumble shutter valve actuator. (See VARIABLE TUMBLE SHUTTER VALVE ACTUATOR REMOVAL/INSTALLATION).

VARIABLE TUMBLE SHUTTER VALVE POSITION SENSOR INSPECTION

CAUTION:

1. Disconnect the negative battery cable.

2. Remove the fresh-air duct and air cleaner as a single unit. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION).

3. Disconnect the variable tumble shutter valve actuator connector.

4. Verify terminal A value (variable tumble shutter valve position sensor output voltage) when battery voltage is applied to terminal B or D.

Mazda 2. VARIABLE TUMBLE SHUTTER VALVE POSITION SENSOR INSPECTION

Mazda 2. VARIABLE TUMBLE SHUTTER VALVE POSITION SENSOR INSPECTION

READ NEXT:

 Engine Coolant Temperature (ECT) Sensor

ENGINE COOLANT TEMPERATURE (ECT) SENSOR REMOVAL/INSTALLATION WARNING: When the engine is hot, it can badly burn. Turn off the engine and wait until it is cool before removing the ECT sensor. ECT

 Mass Air Flow (MAF)/Intake Air Temperature (IAT) Sensor

MASS AIR FLOW (MAF)/INTAKE AIR TEMPERATURE (IAT) SENSOR REMOVAL/INSTALLATION CAUTION: Neither the MAF nor the IAT sensor cannot be removed as a single unit. When replacing the MAF or IAT sensor,

 Manifold Absolute Pressure (MAP) Sensor

MANIFOLD ABSOLUTE PRESSURE (MAP) SENSOR REMOVAL/INSTALLATION 1. Disconnect the negative battery cable. 2. Remove the fresh-air duct and the air cleaner as a single unit. (See INTAKE-AIR SYSTEM REMOV

SEE MORE:

 Windscreen Wipers and Washer

The ignition must be switched ON to use the wipers. WARNING Use only windscreen washer fl uid or plain water in the reservoir: Using radiator antifreeze as washer fl uid is dangerous. If sprayed on the windscreen, it will dirty the windscreen, affect your visibility, and could result in an

 Air Bag System Wiring Diagram

FOREWORD Outline The OBD (on-board diagnostic) system has the following functions: Malfunction detection function: Detects malfunctions in the air bag system and outputs DTCs. PID/data monitor function: Reads out specific input/output signals and the system status. Diagnostic DTCs can

© 2016-2021 Copyright www.m2info.net