Mazda 2: Modifi cation and Add-On Equipment
Mazda2 DJ 2014–2021 Owners Manual / Before Driving / Security System / Modifi cation and Add-On Equipment
Mazda cannot guarantee the immobilizer and the theft-deterrent systems' operation if the system has been modifi ed or if any add-on equipment has been installed.
CAUTION
To avoid damage to the vehicle, do not modify the system or install any add-on equipment to the immobilizer and the theft-deterrent systems or the vehicle.
READ NEXT:
Immobilizer System
The immobilizer system allows the
engine to start only with a key the system
recognises.
If someone attempts to start the engine
with an unrecognised key, the engine
will not start, thereby hel
Theft-Deterrent System
If the theft deterrent system detects an
inappropriate entry into the vehicle or
the intrusion sensor detects movement
in the vehicle which could result in the
vehicle (with the intrusion sensor)
SEE MORE:
Front Oil Seal
FRONT OIL SEAL REPLACEMENT
1. Disconnect the negative battery cable.
2. Remove the drive belt. (See DRIVE BELT REMOVAL/INSTALLATION).
3. Remove in the order indicated in the table.
4. Install in the reverse order of removal.
Crankshaft pulley lock bolt
Crankshaft pulley
Front oil seal
Crank
DriveLine & Axle
GENERAL PROCEDURES (FRONT AND REAR AXLES)
Wheel and Tire Installation
1. When installing the wheels and tires, tighten the wheel nuts in a criss-cross
pattern to the
following tightening torque.
Tightening Torque
88-118 N*m {9.0-12 kgf*m, 65-87 ft*lbf}
Connector Disconnection
1. Disconnect t
© 2016-2021 Copyright www.m2info.net