Mazda 2: Mechanical System Test

Mechanical System Test Preparation

1. Engage the parking brake and use wheel chocks at the front and rear of the wheels.

2. Inspect the engine coolant. (See ENGINE COOLANT LEVEL INSPECTION).

3. Inspect the engine oil. (See ENGINE OIL LEVEL INSPECTION).

4. Inspect the ATF. (See AUTOMATIC TRANSAXLE FLUID (ATF) INSPECTION).

5. Inspect the idle speed. (See ENGINE TUNE-UP).

6. Inspect the ignition timing. (See ENGINE TUNE-UP).

7. Verify that no DTCs recorded. (See ON-BOARD DIAGNOSTIC SYSTEM DTC INSPECTION).

Line Pressure Test

1. Perform "Mechanical System Test Preparation". (See Mechanical System Test Preparation).

WARNING:

NOTE:

2. Perform the line pressure test at the engine idle speed for the D position.

  1. Remove the square-head plug from the line pressure inspection port.

Mazda 2. MECHANICAL SYSTEM TEST

  1. Connect the SSTs as following:
    • When using the oil pressure gauge set (49 0378 400C), connect the SSTs (49 H019 002, 49 0378 400C, 49 B019 901B) to the line pressure inspection port as shown in the figure.
    • When using the oil pressure gauge set (49 D019 9A2), connect the SSTs (49 D019 910, 49 D019 911, 49 D019 913, 49 D019 909, 49 D019 908) to the line pressure inspection port as shown in the figure.

Mazda 2. MECHANICAL SYSTEM TEST

  1. Start the engine.
  2. Warm-up the transaxle until the ATF temperature reaches 60-70

      READ NEXT:

       Road Test

      WARNING: When performing a road test, be aware of other vehicles, people, impediments, etc. to avoid an accident. NOTE: When the legal speed limit must be exceeded, use a chassis dynamometer.

       Automatic Transaxle Fluid (ATF)

      AUTOMATIC TRANSAXLE FLUID (ATF) INSPECTION Automatic transaxle Fluid (ATF) Condition Inspection 1. Remove the dipstick. 2. One way of determining whether the transaxle should be disassembled is by n

       Transaxle Range (TR) Switch

      TRANSAXLE RANGE (TR) SWITCH INSPECTION CAUTION: Water or foreign objects entering the connector can cause a poor connection or corrosion. Be sure not to drop water or foreign objects on the conne

      SEE MORE:

       Service Cautions

      Injury/damage Prevention Precautions Depending on the vehicle, the cooling fan may operate suddenly even when the ignition is switch to off. Therefore, keep hands and tools away from the cooling fan even if the cooling fan is not operating to prevent injury to personnel or damage to the co

       Crankshaft Position (CKP) Sensor

      CRANKSHAFT POSITION (CKP) SENSOR REMOVAL/INSTALLATION CAUTION: When replacing the CKP sensor, make sure there is no foreign material on it such as metal shavings. If it is installed with foreign material, the sensor output signal will malfunction resulting from fluctuation in magnetic flux a

    © 2016-2021 Copyright www.m2info.net