Mazda 2 2007-2014 Service Manual
Mazda 2 2007-2014 Service Manual
- General Information
- How To Use This Manual
- Service Cautions
- Electrical System
- Jacking Positions, Vehicle Lift (2 Supports) and Safety Stand (Rigid Rack) Positions
- Identification Number Locations
- Pre-Delivery Inspection
- Scheduled Maintenance
- Engine
- Foreword
- On-Board Diagnostic Test
- OBD-II Drive Mode
- DTC Table
- Symptom Diagnostic Index
- Intermittent Concern Troubleshooting
- Engine Control System Operation Inspection
- Engine System
- Lubrication System
- Cooling System
- Intake-air System
- Fuel System
- Emission System
- Ignition System
- Charging System
- Starting System
- Control System
- Suspension
- Tire Pressure Monitoring System (TPMS)
- Malfunctioning Wheel Unit Identification
- Precaution
- Symptom Troubleshooting
- General Procedures
- Wheel Alignment Pre-inspection
- Wheel and Tire Specification
- Wheel Unit ID Registration
- Front Suspension
- Rear Suspension
- DriveLine & Axle
- Brakes
- Dynamic Stability Control System
- Precaution
- Symptom Troubleshooting
- General Procedures
- Conventional Brake System
- Parking Brake System
- DSC
- Transmission & Transaxle
- On-Board Diagnostic System
- Automatic Transaxle Control System
- Clutch
- Manual Transaxle
- Manual Transaxle Shift Mechanism
- Automatic Transaxle
- Automatic Transaxle Shift Mechanism
- Steering
- HVAC
- Restraints
READ NEXT:
How To Use This Manual
Range of Topics
This manual contains procedures for performing all required service
operations. The procedures are divided into the following five basic
operations:
Removal/Installation
Disas
Service Cautions
Injury/damage Prevention Precautions
Depending on the vehicle, the cooling fan may operate suddenly even when
the ignition
is switch to off. Therefore, keep hands and tools away from the cooling
SEE MORE:
DTC B1127:11/B1127:12/B1127:13/B1127:19/B1127:1A
System Malfunction Location
Detection Condition
WARNING:
Detection conditions are for understanding the DTC outline before
performing an
inspection. Performing an inspection according to only the detection
conditions may
cause injury due to an operating error, or damage the system. When
p
Starting System
STARTING SYSTEM LOCATION INDEX
Starter interlock switch (MTX)
(See STARTER INTERLOCK SWITCH INSPECTION)
Starter
(See STARTER REMOVAL/INSTALLATION)
(See STARTER INSPECTION)
(See STARTER DISASSEMBLY/ASSEMBLY)
STARTER REMOVAL/INSTALLATION
WARNING:
Remove and install all parts whe
© 2016-2021 Copyright www.m2info.net