Mazda 2: Laser Sensor
The Smart City Brake Support (SCBS) laser sensor is installed at the top of the windscreen near the rearview mirror.
Always keep the surface of the windscreen around the laser sensor clean to assure proper operation of the Smart City Brake Support (SCBS) system.
WARNING
As there is the possibility of eye damage occurring from the laser, always heed the following precautions:
- Never remove the sensor.
- A removed sensor will not meet the conditions for a class 1M laser under the IEC 60825-1 specifi cation and therefore eye safety cannot be assured.
- Do not peer into the sensor using optical instruments with a magnifi cation function such as magnifying glasses, and microscopic and objective lenses within a distance of 100 mm (3.94 in) from the sensor.
Laser sensor radiation data
Maximum average power: 45 mW
Pulse duration: 33 ns
Wavelength: 905 nm
Divergence angle (horizontal×vertical): 28 degrees×12 degrees
READ NEXT:
Radar Sensors (Rear)
Your vehicle is equipped with radar sensors (rear). The following systems
also use the radar
sensors (rear).
Blind Spot Monitoring system (BSM)
Rear Cross Traffi c Alert (RCTA)
The radar s
Cruise Control
With cruise control, you can set and automatically maintain any speed of more
than about
25 km/h (16 mph).
WARNING
Do not use the cruise control under the following conditions:
Using the cruise
Tyre Pressure Monitoring System
The Tyre Pressure Monitoring System (TPMS) monitors the air pressure of all
four tyres. If
the air pressure of one or more tyres is too low, the system warns the driver by
indicating the
tyre pr
SEE MORE:
Rocking the Vehicle
WARNING
Do not spin the wheels at high speed,
and do not allow anyone to stand
behind a wheel when pushing the
vehicle:
When the vehicle is stuck, spinning
the wheels at high speed is dangerous.
The spinning tyre could overheat and
explode. This could cause serious
injuries.
CAUTION
Too
Variable Valve Timing Actuator
VARIABLE VALVE TIMING ACTUATOR INSPECTION
CAUTION:
The variable valve timing actuator cannot be disassembled since it is a
precision unit.
1. Disconnect the negative battery cable.
2. Remove the fresh-air duct and the air cleaner as a single unit. (See
INTAKE-AIR SYSTEM REMOVAL/INSTALLATION).
© 2016-2021 Copyright www.m2info.net