Mazda 2: Jacking Positions, Vehicle Lift (2 Supports) and Safety Stand (Rigid Rack) Positions

Mazda 2 2007-2014 Service Manual / General Information / Jacking Positions, Vehicle Lift (2 Supports) and Safety Stand (Rigid Rack) Positions

Jacking Positions

WARNING:

Front

NOTE:

Rear

Mazda 2. Jacking Positions, Vehicle Lift (2 Supports) and Safety Stand (Rigid Rack) Positions

Vehicle Lift Positions, Safety Stand Positions

Front and rear

WARNING:

CAUTION:

Mazda 2. Jacking Positions, Vehicle Lift (2 Supports) and Safety Stand (Rigid Rack) Positions

TOWING

Mazda 2. Jacking Positions, Vehicle Lift (2 Supports) and Safety Stand (Rigid Rack) Positions

CAUTION:

Mazda 2. Jacking Positions, Vehicle Lift (2 Supports) and Safety Stand (Rigid Rack) Positions

CAUTION:

Mazda 2. Jacking Positions, Vehicle Lift (2 Supports) and Safety Stand (Rigid Rack) Positions

Vehicle Securing Position

Mazda 2. Jacking Positions, Vehicle Lift (2 Supports) and Safety Stand (Rigid Rack) Positions

CAUTION:

READ NEXT:

 Identification Number Locations

Vehicle Identification Number (VIN) The VIN marking position is located on the floor on the front passenger-side. If the VIN plate is adhered to the dashboard, it is located in the position

 Pre-Delivery Inspection

Pre-Delivery Inspection Table Exterior INSPECT and ADJUST, if necessary, the following items to specification: Glass, exterior bright metal and paint for damage Wheel lug nuts All weatherstrips fo

 Scheduled Maintenance

Scheduled Maintenance Table for U.S.A., CANADA and Puerto Rico Schedule 1: (Normal Driving Conditions) for U.S.A. The vehicle is mainly operated where none of the "unique driving conditions" apply.

SEE MORE:

 Scheduled Maintenance

Scheduled Maintenance Table for U.S.A., CANADA and Puerto Rico Schedule 1: (Normal Driving Conditions) for U.S.A. The vehicle is mainly operated where none of the "unique driving conditions" apply. Chart symbols I: Inspect: Inspect and clean, repair, adjust, fill up, or replace if necessary.

 A/C Unit

A/C UNIT REMOVAL/INSTALLATION 1. Set the air intake mode to REC. 2. Disconnect the negative battery cable. 3. Collect the refrigerant. (See REFRIGERANT CHARGING). 4. Drain the engine coolant. (See ENGINE COOLANT REPLACEMENT). 5. Remove the following parts: Glove compartment (See GLOVE COMPARTM

© 2016-2021 Copyright www.m2info.net