Mazda 2: Input/Turbine Speed Sensor
INPUT/TURBINE SPEED SENSOR INSPECTION
CAUTION:
- Water or foreign objects entering the connector can cause a poor
connection or
corrosion. Be sure not to drop water or foreign objects on the connector
when
disconnecting it.
On-Vehicle Inspection
1. Disconnect the input/turbine speed sensor connector.
- Disconnect the negative battery cable.
- Disconnect the input/turbine speed sensor connector.

2. Measure the resistance between the input/turbine speed sensor terminals A
and B.

- If there is any malfunction, replace the input/turbine speed sensor.
(See INPUT/TURBINE SPEED SENSOR REMOVAL/INSTALLATION).
Input/turbine speed sensor specification
Off-Vehicle Inspection
1. Measure the resistance between the input/turbine speed sensor terminals A
and B.

- If there is any malfunction, replace the input/turbine speed sensor.
Input/turbine speed sensor specification
INPUT/TURBINE SPEED SENSOR REMOVAL/INSTALLATION
CAUTION:
- Water or foreign objects entering the connector can cause a poor
connection or
corrosion. Be sure not to drop water or foreign objects on the connector
when
disconnecting it.
- Always use a new bolt. If the removed bolt is reused, it may cause oil
leakage.
- A sealant coating is applied to the input/turbine speed sensor
installation bolt to
prevent oil leakage from the installation bolt hole which passes through the
component.
- If foreign materials are stuck to the sensor, disturbance by magnetic
flux can cause
sensor output to be abnormal and thereby negatively affect control. Make
sure that
foreign materials such as iron filings are not stuck to the sensor during
installation.
1. Disconnect the negative battery cable.
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.

- Connector
- Input/turbine speed sensor
- O-ring
READ NEXT:
VEHICLE SPEED SENSOR (VSS) INSPECTION
CAUTION:
Water or foreign objects entering the connector can cause a poor
connection or
corrosion. Be sure not to drop water or foreign objects on the connec
SOLENOID VALVE INSPECTION
CAUTION:
Water or foreign objects entering the connector can cause a poor
connection or
corrosion. Be sure not to drop water or foreign objects on the connector
when
PCM INSPECTION
CAUTION:
Water or foreign objects entering the connector can cause a poor
connection or
corrosion. Be sure not to drop water or foreign objects on the connector
when
disconnecti
SEE MORE:
Standard tire
*3 Verify the tire label attached to the actual vehicle on vehicles without
TPMS.
Spare tire
WHEEL BALANCE ADJUSTMENT (ALUMINUM ALLOY WHEEL)
CAUTION:
Adjust the outer wheel balance first, then the inner wheel balance.
Be careful not to scratch the wheels.
Adhesive-type Balance
This chart indicates the applicable SRS equipment that will deploy depending
on the type of
collision.
(The illustrations are the representative cases of collisions.)
X : The SRS air bag equipment is designed to deploy in a collision.
*1 (With Front Passenger Air Bag Deactivation Switc
© 2016-2022 Copyright www.m2info.net
