Mazda 2: How To Use This Manual

Range of Topics

Service Procedure

Inspection, adjustment

Mazda 2. Service Procedure

Repair procedure

1. Most repair operations begin with an overview illustration. It identifies the components, shows how the parts fit together, and describes visual part inspection. However, only removal/installation procedures that need to be performed methodically have written instructions.

2. Expendable parts, tightening torques, and symbols for oil, grease, and sealant are shown in the overview illustration. In addition, symbols indicating parts requiring the use of special service tools or equivalent are also shown.

3. Procedure steps are numbered and the part that is the main point of that procedure is shown in the illustration with the corresponding number. Occasionally, there are important points or additional information concerning a procedure. Refer to this information when servicing the related part.

Mazda 2. Repair procedure

Mazda 2. Repair procedure

Symbols

Mazda 2. Symbols

Advisory Messages

Warning

Caution

Note

Specification

Upper and lower limits

Troubleshooting Procedure

Basic flow of troubleshooting

Mazda 2. Basic flow of troubleshooting

DTC troubleshooting flow (on-board diagnostic)

Diagnostic index

Quick diagnosis chart (If mentioned)

Symptom troubleshooting

Procedures for Use

Using the basic inspection (transmission/transaxle)

Mazda 2. How To Use This Manual

Using the DTC troubleshooting flow

Mazda 2. How To Use This Manual

Mazda 2. How To Use This Manual

Mazda 2. Service Cautions

Using the diagnostic index

Mazda 2. How To Use This Manual

Using the quick diagnosis chart

Mazda 2. How To Use This Manual

Mazda 2. How To Use This Manual

Using the symptom troubleshooting

Mazda 2. How To Use This Manual

Mazda 2. How To Use This Manual

Units

Mazda 2. Units

Mazda 2. Units

Conversion to SI Units (Syst

READ NEXT:

 Service Cautions

Injury/damage Prevention Precautions Depending on the vehicle, the cooling fan may operate suddenly even when the ignition is switch to off. Therefore, keep hands and tools away from the cooling

 Electrical System

Electrical Parts Battery cable Before disconnecting connectors or removing electrical parts, disconnect the negative battery cable. Wiring Harness To remove the wiring harness from the clip i

 Jacking Positions, Vehicle Lift (2 Supports) and Safety Stand (Rigid Rack) Positions

Jacking Positions WARNING: Improperly jacking a vehicle is dangerous. The vehicle can slip off the jack and cause serious injury. Use only the correct front and rear jacking points and block the

SEE MORE:

 Automatic Transaxle Fluid (ATF)

AUTOMATIC TRANSAXLE FLUID (ATF) INSPECTION Automatic transaxle Fluid (ATF) Condition Inspection 1. Remove the dipstick. 2. One way of determining whether the transaxle should be disassembled is by noting: If the ATF is muddy or varnished. If the ATF smells strange or unusual. ATF condition Tr

 Valve Clearance

VALVE CLEARANCE INSPECTION 1. Disconnect the negative battery cable. 2. Remove the splash shield (RH). (See DRIVE BELT REMOVAL/INSTALLATION). 3. Remove the fresh-air duct and the air cleaner as a single unit. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION). 4. Remove the ignition coils. (See IGNITI

© 2016-2022 Copyright www.m2info.net