Mazda 2: Headlight Washer

The ignition must be switched ON and the headlights must be turned on.

The headlight washers operate automatically once every fi fth time the windscreen washer operates.

If you want to operate headlight washers, double fl ick the wiper lever.

Headlight Washer


NOTE

If air enters the headlight washer fl uid pipe under conditions such as when the vehicle is brand-new or after an empty washer tank is replenished with washer fl uid, washer fl uid will not spray even when the wiper lever is operated.

If this occurs, perform the following procedure:

  1. Start the engine.
  2. Turn on the headlights.
  3. Double fl ick the wiper lever several times until the washer fl uid sprays.

READ NEXT:

 Rear Window Defogger

The rear window defogger clears fog from the rear window. The ignition must be switched ON to use the defogger. Press the switch to turn on the rear window defogger. The rear window defogger

 Hazard Warning Flasher

The hazard warning lights should always be used when you stop on or near a roadway in an emergency. The hazard warning lights warn other drivers that your vehicle is a traffi c hazard and tha

 Brake

SEE MORE:

 DSC

DSC LOCATION INDEX DSC HU/CM (See DSC SYSTEM WIRING DIAGRAM.) (See DSC SYSTEM INSPECTION.) (See DSC HU/CM REMOVAL/INSTALLATION.) (See DSC HU/CM INSPECTION.) Brake fluid pressure sensor (Built into DSC HU/CM) (See BRAKE FLUID PRESSURE SENSOR INSPECTION.) (See DSC SENSOR INITIALIZ

 Rear Axle

REAR AXLE LOCATION INDEX Rear axle component REAR AXLE INSPECTION Wheel Bearing Play Inspection 1. Inspect the wheel bearing play in the same way as the front axle. (See WHEEL HUB, STEERING KNUCKLE INSPECTION). If it exceeds the specification, replace the wheel hub component. (See WHEEL HUB

© 2016-2021 Copyright www.m2info.net