Mazda 2: Head Restraints

Your vehicle is equipped with head restraints on front seats, rear outboard seats* and the rear centre seat * . The head restraints are intended to help protect you and the passengers from neck injury.

WARNING

Always drive with the head restraints installed when seats are being used and make sure they are properly adjusted.

In addition, always raise the head restraints mentioned below when they are being used: Driving with the head restraints adjusted too low or removed is dangerous. With no support behind your head, your neck could be seriously injured in a collision.

(Head restraints which must be raised for use)

Height Adjustment

Adjust the head restraint so that the centre is even with the top of the passenger's ears.

Height Adjustment


To raise a head restraint, pull it up to the desired position.

To lower the head restraint, press the stopcatch release, then push the head restraint down.

Front outboard seat

Front outboard seat


Rear outboard seat *

Rear outboard seat


Rear centre seat *

Rear centre seat


Removal/Installation

To remove the head restraint, pull it up while pressing the stop-catch.

To install the head restraint, insert the legs into the holes while pressing the stopcatch.

WARNING

Always drive with the head restraints installed when seats are being used and make sure they are properly installed: Driving with the head restraints not installed is dangerous. With no support behind your head, your neck could be seriously injured in a collision.

After installing a head restraint, try lifting it to make sure that it does not pull out: Driving with an unsecured head restraint is dangerous as the effectiveness of the head restraint will be compromised which could cause it to unexpectedly detach from the seat.

CAUTION

READ NEXT:

 Seat Belt Systems

 Seat Belt Precautions

Seat belts help to decrease the possibility of severe injury during accidents and sudden stops. Mazda recommends that the driver and all passengers always wear seat belts. Front seat and rear ou

 Seat Belt

Fastening the Seat Belt Position the lap belt as low as possible, not on the abdominal area, then adjust the shoulder belt so that it fi ts snugly against your body. Unfastening the Seat

SEE MORE:

 Cup Holder

WARNING Never use a cup holder to hold hot liquids while the vehicle is moving: Using a cup holder to hold hot liquids while the vehicle is moving is dangerous. If the contents spill, you could be scalded. Do not put anything other than cups or drink cans in cup holders: Putting objects o

 Jacking Positions, Vehicle Lift (2 Supports) and Safety Stand (Rigid Rack) Positions

Jacking Positions WARNING: Improperly jacking a vehicle is dangerous. The vehicle can slip off the jack and cause serious injury. Use only the correct front and rear jacking points and block the wheels. Use safety stands to support the vehicle after it has been lifted. Front NOTE: To preven

© 2016-2022 Copyright www.m2info.net