Mazda 2: Fuses

Your vehicle's electrical system is protected by fuses.

If any lights, accessories, or controls do not work, inspect the appropriate circuit protector. If a fuse has blown, the inside element will be melted.

If the same fuse blows again, avoid using that system and consult an expert repairer, we recommend an Authorised M

Fuse Replacement

Replacing the fuses on the vehicle's left side

If the electrical system does not work, fi rst inspect the fuses on the vehicle's left side.

  1. Make sure the ignition is switched off, and other switches are off.
  2. Open the fuse panel cover.

Replacing the fuses on the vehicle's left side


  1. Pull the fuse straight out with the fuse puller provided on the fuse block located in the engine compartment.

  2. Inspect the fuse and replace it if it is blown.

  3. Insert a new fuse of the same amperage rating, and make sure it fi ts tightly. If it does not fi t tightly, have an expert install it. We recommend an Authorised Mazda Repairer.

    If you have no spare fuses, borrow one of the same rating from a circuit not essential to vehicle operation, such as the AUDIO or OUTLET circuit.

CAUTION

Always replace a fuse with a genuine Mazda fuse or equivalent of the same rating. Otherwise you may damage the electric system.

  1. Reinstall the cover and make sure that it is securely installed.

Replacing the fuses under the bonnet

If the headlights or other electrical components do not work and the fuses in the cabin are normal, inspect the fuse block under the bonnet. If a fuse is blown, it must be replaced. Follow these steps:

  1. Make sure the ignition is switched off, and other switches are off
  2. Remove the fuse block cover.

Replacing the fuses under the bonnet


  1. If any fuse but the MAIN fuse is blown, replace it with a new one of the same amperage rating .

WARNING

Do not replace the main fuse and multiplex slow blow fuse by yourself.

Have an Authorised Mazda Repairer perform the replacement: Replacing these fuses by yourself is dangerous because they are high current fuses. Incorrect replacement could cause an electrical shock or a short circuit resulting in a fire.

  1. Reinstall the cover and make sure that it is securely installed.

Fuse Panel Description

Fuse block (Engine compartment)

Fuse block (Engine compartment)


Fuse block (Engine compartment)


Fuse block (Engine compartment)


Fuse block (Left side)

Fuse block (Left side)


Fuse block (Left side)


READ NEXT:

 Appearance Care

 Exterior Care

The paintwork on your Mazda represents the latest technical developments in composition and methods of application. Environmental hazards, however, can harm the paint's protective properties, if

 Interior Care

WARNING Do not spray water in the cabin: Splashing water on electrical parts such as the audio unit and switches is dangerous as it could cause a malfunction or a fire. Instrument panel Precauti

SEE MORE:

 Emission System

EMISSION SYSTEM LOCATION INDEX Engine Compartment Side EGR valve (See EGR VALVE REMOVAL/INSTALLATION) (See EGR VALVE INSPECTION) Ventilation hose Purge solenoid valve (See PURGE SOLENOID VALVE REMOVAL/INSTALLATION) (See PURGE SOLENOID VALVE INSPECTION) Positive crankcase ventil

 Rear Axle

REAR AXLE LOCATION INDEX Rear axle component REAR AXLE INSPECTION Wheel Bearing Play Inspection 1. Inspect the wheel bearing play in the same way as the front axle. (See WHEEL HUB, STEERING KNUCKLE INSPECTION). If it exceeds the specification, replace the wheel hub component. (See WHEEL HUB

© 2016-2022 Copyright www.m2info.net