Mazda 2: Fuel Tank Pressure Sensor
FUEL TANK PRESSURE SENSOR REMOVAL/INSTALLATION
CAUTION:
- The fuel tank pressure sensor cannot be removed as a single unit. When
replacing the
fuel tank pressure sensor, replace it together with the evaporative hose
component as a
single unit.
1. Disconnect the negative battery cable.
2. Disconnect the fuel tank pressure sensor connector.
3. Remove the wiring harness from the fuel tank pressure sensor bracket.
4. Remove the evaporative hose from the charcoal canister bracket.
5. Disconnect the quick release connectors and remove the evaporative hose
component.
(See QUICK RELEASE CONNECTOR (EMISSION SYSTEM) REMOVAL/INSTALLATION).

6. Install in the reverse order of removal.
FUEL TANK PRESSURE SENSOR INSPECTION
CAUTION:
- The fuel tank pressure sensor cannot be removed as a single unit. When
replacing the
fuel tank pressure sensor, replace it together with the evaporative hose
component as a
single unit.
1. Connect the M-MDS to the DLC-2.
2. Switch the ignition to ON.
3. Verify that the Fuel tank pressure sensor output voltage (M-MDS PID: FTP) is
within the specification. (See PCM INSPECTION).
- If not as specified, replace the evaporative hose component.
PCM TEMPERATURE SENSOR REMOVAL/INSTALLATION
CAUTION:
- The PCM temperature sensor cannot be removed as a single unit. When
replacing the
PCM temperature sensor, replace it together with the PCM as a single unit.
1. Remove the PCM. (See PCM REMOVAL/INSTALLATION).
PCM TEMPERATURE SENSOR INSPECTION
CAUTION:
- The PCM temperature sensor cannot be removed as a single unit. When
replacing the
PCM temperature sensor, replace it together with the PCM as a single unit.
1. Connect the M-MDS to the DLC-2.
2. Turn the ignition switch to the ON position.
3. Select PCM_T on the M-MDS.
4. Verify that the PCM_T PID temperature is within the specification.
- If not as verified, replace the PCM. (See PCM REMOVAL/INSTALLATION).
PCM temperature sensor specification
READ NEXT:
TIRE PRESSURE MONITORING SYSTEM (TPMS) WIRING DIAGRAM
TIRE PRESSURE MONITORING SYSTEM (TPMS) ON-BOARD DIAGNOSIS
On-Board Diagnostic (OBD) Test Description
The OBD test inspects the integrity and fu
NOTE:
The tire pressure monitoring system (TPMS) does not identify the
location of the
malfunctioning wheel unit on the vehicle (RF, LF, LR, RR). The TPMS
identifies each
wheel unit as No.1, N
SEE MORE:
System Malfunction Location
Seat weight sensor collision detection
Detection Condition
WARNING:
Detection conditions are for understanding the DTC outline before
performing an
inspection. Performing an inspection according to only the detection
conditions may
cause injury due to an operat
WARNING
Do not leave the key in your vehicle
with children and keep them in a place
where your children will not fi nd or
play with them:
Leaving children in a vehicle with the
key is dangerous. This could result in
someone being badly injured or even
killed. Children may fi nd these keys
t
© 2016-2022 Copyright www.m2info.net
