Mazda 2: Fuel Pump Unit

FUEL PUMP UNIT REMOVAL/INSTALLATION

WARNING:

1. Complete the "BEFORE SERVICE PRECAUTION". (See BEFORE SERVICE PRECAUTION).

2. Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION).

3. Remove the rear seat cushion. (See REAR SEAT CUSHION REMOVAL/INSTALLATION).

4. Remove the service hole cover.

Mazda 2. FUEL PUMP UNIT REMOVAL/INSTALLATION

5. Remove in the order indicated in the table.

Mazda 2. FUEL PUMP UNIT REMOVAL/INSTALLATION

  1. Fuel pump unit connector
  2. Quick release connector
  3. Fuel pump cap
  4. Fuel pump unit

6. Install in the reverse order of removal.

7. Complete the "AFTER SERVICE PRECAUTION". (See AFTER SERVICE PRECAUTION).

Fuel Pump Cap Removal Note

CAUTION:

1. Remove the fuel pump cap using the SST.

Mazda 2. FUEL PUMP UNIT REMOVAL/INSTALLATION

Fuel Pump Cap Installation Note

NOTE:

1. Align the fuel tank mark (No.1) with the fuel pump unit mark as shown in the figure.

Mazda 2. FUEL PUMP UNIT REMOVAL/INSTALLATION

2. Align the threading start point of the fuel pump cap with the fuel tank mark (No.2) as shown in the figure.

Mazda 2. FUEL PUMP UNIT REMOVAL/INSTALLATION

3. While keeping the fuel pump unit from rising up, tighten the fuel pump cap by hand 220- 260

READ NEXT:

 Quick Release Connector

QUICK RELEASE CONNECTOR REMOVAL/INSTALLATION WARNING: Fuel is very flammable liquid. If fuel spills or leaks from the pressurized fuel system, it will cause serious injury or death and facility b

 Fuel Injector

FUEL INJECTOR REMOVAL/INSTALLATION WARNING: Fuel line spills and leakage are dangerous. Fuel can ignite and cause serious injuries or death. Fuel can also irritate skin and eyes. To prevent this,

 Exhaust System

EXHAUST SYSTEM INSPECTION 1. Start the engine and inspect each exhaust system component for exhaust gas leakage. If there is leakage, repair or replace the appropriate component. (See EXHAUST SYS

SEE MORE:

 Instrumentation/Driver Info.

INSTRUMENTATION/DRIVER INFO. LOCATION INDEX Oil pressure switch Horn Ambient temperature sensor Instrument cluster Passenger seat belt reminder Fuel gauge sender unit INSTRUMENT CLUSTER REMOVAL/INSTALLATION CAUTION: When replacing the instrument cluster, always perform the configuration

 SAS Control Module

SAS CONTROL MODULE REMOVAL/INSTALLATION WARNING: Handling the SAS control module improperly can accidentally deploy the air bag modules and pre-tensioner seat belt, which may seriously injure you. Read the air bag system service warnings and cautions before handling the air bag module. (See

© 2016-2021 Copyright www.m2info.net