Mazda 2: Front Seat

Seat Operation

Seat Operation


  1. Seat Slide

To move a seat forward or backward, raise the lever and slide the seat to the desired position and release the lever.

Make sure the lever returns to its original position and the seat is locked in place by attempting to push it forward and backward.

  1. Height Adjustment (Driver's Seat)

To adjust the seat height, move the lever up or down.

  1. Seat Recline

To change the seatback angle, lean forward slightly while raising the lever. Then lean back to the desired position and release the lever.

Make sure the lever returns to its original position and the seatback is locked in place by attempting to push it forward and backward.

Seat Warmer

The front seats are electrically heated. The ignition must be switched ON.

Press the seat warmer switch to illuminate the indicator light while the ignition is switched ON. The mode changes as follow each time the seat warmer switch is pressed.

Seat Warmer


WARNING

Be careful when using the seat warmer: The heat from the seat warmer may be too hot for some people, as indicated below, and could cause a lowtemperature burn.

WARNING

Do not use the seat warmer with anything having high moistureretention ability such as a blanket or cushion on the seat: The seat may be heated excessively and cause a low-temperature burn.

Do not use the seat warmer even when taking a short nap in the vehicle: The seat may be heated excessively and cause a low-temperature burn.

Do not place heavy objects with sharp projections on the seat, or insert needles or pins into it: This could cause the seat to become excessively heated and result in injury from a minor burn.

CAUTION

Do not use organic solvents to clean the seat. It may damage the seat surface and the heater.

NOTE

READ NEXT:

 Rear Seat

Split/One-piece Folding the Seatback By lowering the rear seatback(s) the luggage compartment space can be expanded. WARNING Do not drive the vehicle with occupants on folded down seatback(s) o

 Head Restraints

Your vehicle is equipped with head restraints on front seats, rear outboard seats* and the rear centre seat * . The head restraints are intended to help protect you and the passengers from neck in

 Seat Belt Systems

SEE MORE:

 Audio Control Switch Operation

Without Bluetooth ® Hands-Free With Bluetooth ® Hands-Free Adjusting the Volume To increase the volume, press up the volume switch ( ). To decrease the volume, press down the volume switch ( ). Seek Switch AM/FM radio (Type A/Type C/Type D), MW/LW/FM radio (Type B) Press the

 Changing a Flat Tyre (With Spare Tyre)

NOTE If the following occurs while driving, it could indicate a fl at tyre. Steering becomes diffi cult. The vehicle begins to vibrate excessively. The vehicle pulls in one direction. If you have a fl at tyre, drive slowly to a level spot that is well off the road and out of the way

© 2016-2020 Copyright www.m2info.net