Mazda 2: Front Oil Seal

FRONT OIL SEAL REPLACEMENT

1. Disconnect the negative battery cable.

2. Remove the drive belt. (See DRIVE BELT REMOVAL/INSTALLATION).

3. Remove in the order indicated in the table.

4. Install in the reverse order of removal.

Mazda 2. FRONT OIL SEAL REPLACEMENT

  1. Crankshaft pulley lock bolt
  2. Crankshaft pulley
  3. Front oil seal

Crankshaft Pulley Lock Bolt Removal Note

CAUTION:

1. Fix the crankshaft pulley using the SSTs, and remove the crankshaft pulley lock bolt.

Mazda 2. FRONT OIL SEAL REPLACEMENT

Front Oil Seal Removal Note

1. Remove the oil seal lip using a cutting knife.

2. Remove the oil seal using a flathead screwdriver with the tip protected by a rag to prevent crankshaft oil seal damage.

Mazda 2. FRONT OIL SEAL REPLACEMENT

Front Oil Seal Installation Note

1. Apply clean engine oil to the new front oil seal.

2. Insert the front oil seal into the engine front cover by hand.

3. Tap the front oil seal in using the SST and a hammer.

Mazda 2. FRONT OIL SEAL REPLACEMENT

Mazda 2. FRONT OIL SEAL REPLACEMENT

Pushing distance of the front oil seal (from the edge of the engine front cover)

Crankshaft Pulley Lock Bolt Installation Note

CAUTION:

1. Fix the crankshaft pulley using the SSTs, and tighten the crankshaft pulley installation bolt.

Mazda 2. FRONT OIL SEAL REPLACEMENT

Tightening torque

READ NEXT:

 Rear Oil Seal

REAR OIL SEAL REPLACEMENT 1. Remove the transaxle. (See AUTOMATIC TRANSAXLE REMOVAL/INSTALLATION [FN4A-EL] (ATX) ). (See MANUAL TRANSAXLE REMOVAL/INSTALLATION [F35M-R] (MTX) ). 2. Remove the drive p

 Engine

ENGINE REMOVAL/INSTALLATION WARNING: Fuel vapor is hazardous. It can very easily ignite, causing serious injury and damage. Always keep sparks and flames away from fuel. Fuel line spills and lea

 Lubrication System

LUBRICATION SYSTEM LOCATION INDEX Dipstick (See ENGINE OIL LEVEL INSPECTION) (See ENGINE OIL REPLACEMENT) Oil pressure switch (See OIL PRESSURE INSPECTION) Oil filter (See OIL FIL

SEE MORE:

 Changing a Flat Tyre (With Spare Tyre)

NOTE If the following occurs while driving, it could indicate a fl at tyre. Steering becomes diffi cult. The vehicle begins to vibrate excessively. The vehicle pulls in one direction. If you have a fl at tyre, drive slowly to a level spot that is well off the road and out of the way

 Installing Child-Restraint Systems

Anchor Bracket Anchor brackets for securing childrestraint systems are equipped in the vehicle. Locate each anchor position using the illustration. To install a child-restraint system, if the seat is equipped with a head restraint, remove it. Always follow the instruction manual accompanyi

© 2016-2020 Copyright www.m2info.net