Mazda 2: Front Fog Lights
Can be used when the ignition is switched
ON.
Use this switch to turn on the front fog
lights. The front fog lights will improve
visibility at night and during foggy
conditions.
To turn the front fog lights on, rotate the
fog light switch to the
or
position
(the fog light switch returns to the
position automatically).

The headlight switch must be in the
or
position before turning on the front fog
lights.
The front fog light indicator light in the
instrument cluster illuminates while the
front fog light are on. 
To turn the front fog lights off, do any of
the following:
- Rotate the fog light switch to the
position.
- Turn the headlight switch to the
position.
- Switch the ignition to a position other
than ON.
NOTE
- (With auto-light control)
If the fog light switch is in the
or
position and the headlight
switch
is in the
position, the
front fog
lights will turn on when the
headlights, the exterior lights and
instrument panel illumination turn
on.
- If the fog light switch is rotated to
the
position (the fog light
switch
returns to the
position
automatically), the rear fog light will
also illuminate, and the rear fog light
indicator light in the instrument
cluster will also illuminate.
READ NEXT:
Can be used when the ignition is switched
ON.
The rear fog light helps your vehicle to be
seen.
When the lights are turned on, the rear
fog lights indicator light in the instrument
cluster t
The ignition must be switched ON to use
the turn and lane-change signals.
Direction Indicators
Move the signal lever down (for a left
turn) or up (for a right turn) to the stop
position. The sign
The ignition must be switched ON to use
the wipers.
WARNING
Use only windscreen washer fl uid or
plain water in the reservoir:
Using radiator antifreeze as washer
fl uid is dangerous. If sprayed
SEE MORE:
FRONT DOOR LATCH AND LOCK ACTUATOR REMOVAL/INSTALLATION
1. To access the glass installation bolt, position the front door glass so
that the distance from
the top of the front door glass to the upper part of the front beltline molding
is approx. 110
mm {4.33 in}.
2. Disconnect the negative batter
(Europe and countries conforming to the UNECE 16 regulation)
Provided information in the table shows your child-restraint system
suitability for various
seating position. For installation suitability of other manufacturer
child-restraint system,
carefully consult the manufacturer's instructio
© 2016-2022 Copyright www.m2info.net
