Mazda 2: Front Door Trim

FRONT DOOR TRIM REMOVAL/INSTALLATION

1. Disconnect the negative battery cable.

2. Remove the inner garnish. (See INNER GARNISH REMOVAL/INSTALLATION) 3. Pull the cover of inner handle while remove the tabs.

4. Remove the screw.

5. Pull in the direction of the arrow shown in the figure and remove clips A from the door inner panel using a fastener remover.

6. Remove the front door trim in the direction of the arrow shown in the figure.

7. Remove the inner handle and move the front door trim in the direction of the arrow shown in the figure.

8. Turn the inner handle 90

READ NEXT:

 Rear Door Trim

REAR DOOR TRIM REMOVAL/INSTALLATION 1. Disconnect the negative battery cable. 2. Remove the sail inner garnish. (See SAIL INNER GARNISH REMOVAL/INSTALLATION) 3. Pull the cover of inner handle while r

 Lighting Systems

LIGHTING SYSTEMS LOCATION INDEX Back-up light switch Front combination light Auto light sensor Side turn light Front fog light Cargo compartment light Rear combination light High-mount brak

 Wiper/Washer System

WIPER/WASHER SYSTEM LOCATION INDEX Windshield wiper motor Windshield wiper arm and blade Wiper and washer switch Rain sensor Windshield washer hose Rear washer hose Rear washer nozzle Rear w

SEE MORE:

 Control System

CONTROL SYSTEM LOCATION INDEX BCM (body control module) BODY CONTROL MODULE (BCM) REMOVAL/INSTALLATION CAUTION: When replacing the BCM, the configuration procedure must be performed before removing the BCM. Replacing the BCM without performing the configuration procedure will result in sys

 Determining Malfunctioning Part (HS-CAN) [Multiplex Communication System]

CAUTION: If the malfunctioning part is detected in the communication line, before disconnecting the related connector for inspection, press the connector in the connection direction to verify that there is no looseness or disconnection. When disconnecting the connector, verify that there is

© 2016-2021 Copyright www.m2info.net