Mazda 2 manuals

Mazda 2: Engine System

Mazda 2 2007-2014 Service Manual / Engine / Engine System

ENGINE LOCATION INDEX

Mazda 2. ENGINE LOCATION INDEX

Mazda 2. ENGINE LOCATION INDEX

  1. Engine
    • (See ENGINE TUNE-UP)
    • (See COMPRESSION INSPECTION)
    • (See ENGINE REMOVAL/INSTALLATION)
    • (See ENGINE DISASSEMBLY/ASSEMBLY)
  2. Drive belt
    • (See DRIVE BELT INSPECTION)
    • (See DRIVE BELT REMOVAL/INSTALLATION)
  3. Drive belt auto tensioner
    • (See DRIVE BELT AUTO TENSIONER INSPECTION)
  4. Tappet
    • (See VALVE CLEARANCE INSPECTION)
    • (See VALVE CLEARANCE ADJUSTMENT)
  5. Variable valve timing actuator
    • (See VARIABLE VALVE TIMING ACTUATOR INSPECTION)
    • (See VARIABLE VALVE TIMING ACTUATOR REMOVAL/INSTALLATION)
  6. Oil control valve (OCV)
    • (See OIL CONTROL VALVE (OCV) INSPECTION)
    • (See OIL CONTROL VALVE (OCV) REMOVAL/INSTALLATION)
  7. Timing chain
    • (See TIMING CHAIN REMOVAL/INSTALLATION)
  8. Cylinder head gasket
    • (See CYLINDER HEAD GASKET REPLACEMENT)
  9. Front oil seal
    • (See FRONT OIL SEAL REPLACEMENT)
  10. Rear oil seal
    • (See REAR OIL SEAL REPLACEMENT)

READ NEXT:

 Engine Tune-up

Engine Tune-up Preparation NOTE: If the accelerator pedal is depressed continuously for a specified time, the engine speed may decrease to the idle speed. This is due to the fuel cut control op

 Drive Belt

DRIVE BELT INSPECTION NOTE: Drive belt deflection/tension inspection is not necessary because of the use of the drive belt auto tensioner. 1. Remove the splash shield (RH). 2. Verify that the d

 Valve Clearance

VALVE CLEARANCE INSPECTION 1. Disconnect the negative battery cable. 2. Remove the splash shield (RH). (See DRIVE BELT REMOVAL/INSTALLATION). 3. Remove the fresh-air duct and the air cleaner as a si

SEE MORE:

 Rear Door Trim

REAR DOOR TRIM REMOVAL/INSTALLATION 1. Disconnect the negative battery cable. 2. Remove the sail inner garnish. (See SAIL INNER GARNISH REMOVAL/INSTALLATION) 3. Pull the cover of inner handle while remove the tabs. 4. Remove the screw. 5. Pull in the direction of the arrow shown in the figure and

 Warning Sound is Activated

Lights-On Reminder If lights are on and the ignition is switched to ACC or the ignition is switched off, a continuous beep sound will be heard when the driver's door is opened. NOTE When the ignition is switched to ACC, the “Ignition Not Switched Off (STOP) Warning Beep” (page 7-46

© 2016-2022 Copyright www.m2info.net