Mazda 2: Engine Coolant

Inspecting Coolant Level

WARNING

Do not use a match or live fl ame in the engine compartment. DO NOT ADD COOLANT WHEN THE ENGINE IS HOT: A hot engine is dangerous. If the engine has been running, parts of the engine compartment can become very hot. You could be burned. Carefully inspect the engine coolant in the coolant reservoir, but do not open it.

Switch the ignition to
off and make sure the fan is not running before attempting to work near the cooling fan: Working near the cooling fan when it is running is dangerous. The fan could continue running indefi nitely even if the engine has stopped and the engine compartment temperature is high. You could be hit by the fan and seriously injured.

Do not remove either
cooling system cap when the engine and radiator are hot: When the engine and radiator are hot, scalding coolant and steam may shoot out under pressure and cause serious injury.

NOTE

Changing the coolant should be done by an expert repairer, we recommend an Authorised Mazda Repairer.

Inspect the antifreeze protection and coolant level in the coolant reservoir at least once a year—at the beginning of the winter season—and before travelling where temperatures may drop below freezing.

Inspect the condition and connections of all cooling system and heater hoses.

Replace any that are swollen or deteriorated.

The coolant should be at full in the radiator and between the F or FULL and L marks on the coolant reservoir when the engine is cool.

SKYACTIV-G 1.3 and SKYACTIV-G 1.5

Engine Coolant


SKYACTIV-D 1.5

Engine Coolant


If it is at or near L, add enough coolant to the coolant reservoir to provide freezing and corrosion protection and to bring the level to F or FULL.

Securely tighten the coolant reservoir tank cap after adding coolant.

CAUTION

If the coolant reservoir is empty or new coolant is required frequently, consult an expert repairer, we recommend an Authorised Mazda Repairer.

READ NEXT:

 Brake/Clutch Fluid

Inspecting Brake/Clutch Fluid Level WARNING If the brake/clutch fl uid level is low, have the brakes inspected: A low brake/clutch fl uid level is dangerous. A low level could indicate brake

 Window and Headlight Washer Fluid

Inspecting Washer Fluid Level WARNING Use only windscreen washer fl uid or plain water in the reservoir: Using radiator antifreeze as washer fl uid is dangerous. If sprayed on the windscreen, it

 Body Lubrication

All moving points of the body, such as door and bonnet hinges and locks, should be lubricated each time the engine oil is changed. Use a nonfreezing lubricant on locks during cold weather. Make

SEE MORE:

 Manifold Absolute Pressure (MAP) Sensor

MANIFOLD ABSOLUTE PRESSURE (MAP) SENSOR REMOVAL/INSTALLATION 1. Disconnect the negative battery cable. 2. Remove the fresh-air duct and the air cleaner as a single unit. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION). 3. Disconnect the MAP sensor connector. 4. Remove the MAP sensor 5. Install in

 Push-Starting

Do not push-start your Mazda. WARNING Never tow a vehicle to start it: Towing a vehicle to start it is dangerous. The vehicle being towed could surge forward when its engine starts, causing the two vehicles to collide. The occupants could be injured. CAUTION Do not push-start a vehicle tha

© 2016-2020 Copyright www.m2info.net