Mazda 2: Emergency Stop Signal System
Your Mazda is equipped with an emergency stop signal system that is designed to determine whether you are depressing the brake pedal with greater force than during normal braking such as in a situation requiring emergency braking. If the system determines that such a situation is occurring, it fl ashes all the direction indicators rapidly to caution the driver of the vehicle following behind your vehicle of the sudden braking situation.
The system turns off when it determines that the brake pedal is released or that an emergency braking situation no longer exists based on the reduced vehicle speed.
NOTE
- If you bring your vehicle to a complete stop while all the direction indicators are fl ashing rapidly, the rapid fl ashing of all the direction indicators changes back to the normal fl ashing pattern.
- The emergency stop signal system does not operate at vehicle speeds under about 60 km/h (37 mph).
- If the brake pedal is depressed while driving on slippery roads, the emergency stop signal system could operate causing all the turn and lane change signals to fl ash.
READ NEXT:
Hill Launch Assist (HLA)
Hill Launch Assist (HLA) is a function
which assists the driver in accelerating
from a stop while on a slope. When
the driver releases the brake pedal and
depresses the accelerator pedal while
on
Antilock Brake System (ABS)
The ABS control unit continuously
monitors the speed of each wheel. If
one wheel is about to lock up, the ABS
responds by automatically releasing and
reapplying that wheel's brake.
The driver w
SEE MORE:
Camshaft Position (CMP) Sensor
CAMSHAFT POSITION (CMP) SENSOR REMOVAL/INSTALLATION
CAUTION:
When replacing the CMP sensor, make sure there is no foreign material on
it such as
metal shavings. If it is installed with foreign material, the sensor output
signal will
malfunction resulting from fluctuation in magnetic flux and
DTC B0002:11/B0002:12/B0002:13/B0002:19/B0002:1A
System Malfunction Location
Detection Condition
WARNING:
Detection conditions are for understanding the DTC outline before
performing an inspection. Performing an
inspection according to only the detection conditions may cause injury due
to an operating error, or damage
the system. When per
© 2016-2022 Copyright www.m2info.net
