Mazda 2: DTC U0300:00/U2100:00
System Malfunction Location

Detection Condition
WARNING:
- Detection conditions are for understanding the DTC outline before
performing an
inspection. Performing an inspection according to only the detection
conditions may
cause injury due to an operating error, or damage the system. When
performing an
inspection, always follow the inspection procedure.
- SAS control module configuration setting has not been done correctly
Possible Causes
- SAS control module configuration setting not implemented
- SAS control module configuration setting invalid
- SAS control module malfunction
Diagnostic Procedure


DTC U3000:46/U3000:49
System Malfunction Location

Detection Condition
WARNING:
- Detection conditions are for understanding the DTC outline before
performing an
inspection. Performing an inspection according to only the detection
conditions may
cause injury due to an operating error, or damage the system. When
performing an
inspection, always follow the inspection procedure.
- SAS control module internal malfunction
Possible Causes
- SAS control module malfunction
Diagnostic Procedure


READ NEXT:
System Malfunction Location
Detection Condition
WARNING:
Detection conditions are for understanding the DTC outline before
performing an
inspection. Performing an inspection according to only th
PID/DATA MONITOR DISPLAY
1. Connect the M-MDS(IDS) to the DLC-2.
2. After the vehicle is identified, select the following items from the
initialization screen of
the IDS.
Select "DataLogger".
Sel
Troubleshooting Index
Use the chart below to verify the symptoms of the trouble in order to
diagnose the
appropriate area.
AIR BAG SYSTEM WIRING DIAGRAM (SYMPTOM TROUBLESHOOTING)
NO.1 AIR BAG
SEE MORE:
QUICK RELEASE CONNECTOR REMOVAL/INSTALLATION
WARNING:
Fuel is very flammable liquid. If fuel spills or leaks from the
pressurized fuel system, it
will cause serious injury or death and facility breakage. Fuel can also
irritate skin and
eyes. To prevent this, always complete the "Fuel Line Sa
NOTE:
If the self-test is implemented, the seat weight sensor calibration is
performed. Perform
the DTC inspection in accordance with the following conditions:
Do not place objects on the front seat (passenger side)
Do not touch the front seat (passenger side)
Fix the slide position of th
© 2016-2021 Copyright www.m2info.net