Mazda 2: DTC Table [Immobilizer System (Keyless Entry System) ]

Mazda 2 2007-2014 Service Manual / Body and Accessories / DTC Table [Immobilizer System (Keyless Entry System) ]

NOTE:

Mazda 2. DTC TABLE

Mazda 2. DTC TABLE

Mazda 2. DTC TABLE

* The letters at the beginning of each DTC are only displayed when using the M-MDS, and refer to the following: B= Body system, P= Powertrain system, U= Network communication system

SECURITY LIGHT: 11, DTC: B10D9:87/P1260:00

Mazda 2. SECURITY LIGHT

System Wiring Diagram

Mazda 2. SECURITY LIGHT

Diagnostic Procedure

Mazda 2. SECURITY LIGHT

Mazda 2. SECURITY LIGHT

Mazda 2. SECURITY LIGHT

SECURITY LIGHT: 12, DTC: B10D5:13/P1260:00

Mazda 2. SECURITY LIGHT

Diagnostic Procedure

Mazda 2. SECURITY LIGHT

Mazda 2. SECURITY LIGHT

Mazda 2. SECURITY LIGHT

SECURITY LIGHT: 13, DTC: B10D7:05/P1260:00

Mazda 2. SECURITY LIGHT

Diagnostic Procedure

Mazda 2. SECURITY LIGHT

Mazda 2. SECURITY LIGHT

SECURITY LIGHT: 13, DTC: B10D7:94/P1260:00

Mazda 2. SECURITY LIGHT

Diagnostic Procedure

Mazda 2. SECURITY LIGHT

Mazda 2. SECURITY LIGHT

Mazda 2. SECURITY LIGHT

SECURITY LIGHT: 14, DTC: B10D7:81/P1260:00

Mazda 2. SECURITY LIGHT

Diagnostic Procedure

Mazda 2. SECURITY LIGHT

Mazda 2. SECURITY LIGHT

SECURITY LIGHT: 15, DTC: B10D7:51/P1260:00

Mazda 2. SECURITY LIGHT

Diagnostic Procedure

Mazda 2. SECURITY LIGHT

Mazda 2. SECURITY LIGHT

Mazda 2. SECURITY LIGHT

SECURITY LIGHT: 16, DTC: U0100:87/P1260:00

Mazda 2. SECURITY LIGHT

Diagnostic Procedure

Mazda 2. SECURITY LIGHT

Mazda 2. SECURITY LIGHT

SECURITY LIGHT: 21, DTC: B10D8:00/P1260:00

Mazda 2. SECURITY LIGHT

Diagnostic Procedure

Mazda 2. SECURITY LIGHT

Mazda 2. SECURITY LIGHT

Mazda 2. SECURITY LIGHT

SECURITY LIGHT: 22, DTC: B10DA:51/P1260:00

Mazda 2. SECURITY LIGHT

Diagnostic Procedure

Mazda 2. SECURITY LIGHT

Mazda 2. SECURITY LIGHT

Mazda 2. SECURITY LIGHT

SECURITY LIGHT: 23, DTC: B10DA:62/P1260:00

Mazda 2. SECURITY LIGHT

Diagnostic Procedure

Mazda 2. SECURITY LIGHT

Mazda 2. SECURITY LIGHT

Mazda 2. SECURITY LIGHT

PID/DATA MONITOR INSPECTION [IMMOBILIZER SYSTEM (KEYLESS ENTRY SYSTEM) ]

1. Connect the M-MDS (IDS) to the DLC-2.

2. After the vehicle is identified, select the following items from the initialization screen of the IDS.

  1. Select "DataLogger".
  2. Select "Modules".
  3. Select "IC".

3. Select the applicable PID from the PID table.

4. Verify the PID data according to the directions on the screen.

NOTE:

PID/DATA MONITOR TABLE [IMMOBILIZER SYSTEM (KEYLESS ENTRY SYSTEM) ]

Mazda 2. PID/DATA MONITOR TABLE

READ NEXT:

 Foreword [Multiplex Communication System]

If the CAN system is considered to be the cause of the malfunction based on the repair order form and the malfunctioning symptom, follow the Troubleshooting Procedure. DTCs are also output due t

 Determining Malfunctioning Part (HS-CAN) [Multiplex Communication System]

CAUTION: If the malfunctioning part is detected in the communication line, before disconnecting the related connector for inspection, press the connector in the connection direction to verify tha

 M-MDS and Vehicle Not Communicating [Multiplex Communication System]

CAUTION: Perform the following on-board diagnosis according to FOREWORD [MULTIPLEX COMMUNICATION SYSTEM] troubleshooting procedure. Detection Condition Possible causes of communication errors

SEE MORE:

 DTC B00D5:11/B00D5:12

System Malfunction Location Detection Condition WARNING: Detection conditions are for understanding the DTC outline before performing an inspection. Performing an inspection according to only the detection conditions may cause injury due to an operating error, or damage the system. When p

 Exterior Trim

EXTERIOR TRIM LOCATION INDEX Cowl grille Sail garnish Roof molding Front beltline molding Splash shield Side step molding Mudguard Rear spoiler Rear door garnish Rear beltline molding Door sash film Extractor chamber COWL GRILLE REMOVAL/INSTALLATION 1. Remove the windshield wiper arm

© 2016-2021 Copyright www.m2info.net