Mazda 2: DTC B1129:11/B1129:12/B1129:13/B1129:19/B1129:1A
System Malfunction Location

Detection Condition
WARNING:
- Detection conditions are for understanding the DTC outline before
performing an
inspection. Performing an inspection according to only the detection
conditions may
cause injury due to an operating error, or damage the system. When
performing an
inspection, always follow the inspection procedure.
- Resistance other than 1.54-5.06 ohms detected in passenger-side curtain
air bag
module circuit
- Wiring harness between the passenger-side curtain air bag module and SAS
control
module has a malfunction.
Possible Causes
- Passenger-side curtain air bag module connector malfunction
- Open or short circuit in the wiring harness between the passenger-side
curtain air bag
module and SAS control module
- Passenger-side curtain air bag module malfunction
- SAS control module malfunction
System Wiring Diagram

Diagnostic Procedure




DTC B1193:00
System Malfunction Location
- SAS control module operation (deployment)
Detection Condition
WARNING:
- Detection conditions are for understanding the DTC outline before
performing an
inspection. Performing an inspection according to only the detection
conditions may
cause injury due to an operating error, or damage the system. When
performing an
inspection, always follow the inspection procedure.
- SAS control module operates (deploys) air bag module or pre-tensioner
seat belts
Possible Causes
- SAS control module operation (deployment)
- SAS control module malfunction
Diagnostic Procedure

DTC C0061:29/C0062:29/C0063:29
System Malfunction Location

Detection Condition
WARNING:
- Detection conditions are for understanding the DTC outline before
performing an
inspection. Performing an inspection with only detection conditions may
cause injury
due to an operating error, or damage the system. When performing an
inspection,
always follow the inspection procedure.
- Malfunction in the SAS control module
Possible Causes
- SAS control module malfunction
Diagnostic Procedure


READ NEXT:
System Malfunction Location
DSC HU/CM communication fault
Detection Condition
WARNING:
Detection conditions are for understanding the DTC outline before
performing an inspection. Performing an
System Malfunction Location
Detection Condition
WARNING:
Detection conditions are for understanding the DTC outline before
performing an
inspection. Performing an inspection according to only th
System Malfunction Location
Detection Condition
WARNING:
Detection conditions are for understanding the DTC outline before
performing an
inspection. Performing an inspection according to only th
SEE MORE:
Vehicle Identification Number (VIN)
The VIN marking position is located on the floor on the front
passenger-side.
If the VIN plate is adhered to the dashboard, it is located in the
position shown in the
figure.
Engine Identification Number
SAE Standards
In accordance with new regulat
WARNING:
Always inspect the steering component carefully for any shock or impact
which may
have occurred during a collision or servicing operation. If a damaged part
or a part
suspected of being damaged is used, it could result in an unexpected
accident due to
the steering mechanism being
© 2016-2022 Copyright www.m2info.net
