Mazda 2: DTC B1128:11/B1128:12/B1128:13/B1128:19/B1128:1A
System Malfunction Location

Detection Condition
WARNING:
- Detection conditions are for understanding the DTC outline before
performing an
inspection. Performing an inspection according to only the detection
conditions may
cause injury due to an operating error, or damage the system. When
performing an
inspection, always follow the inspection procedure.
- Resistance other than 1.54-5.06 ohms detected in driver-side curtain air
bag
module circuit
- Wiring harness between the driver-side curtain air bag module and SAS
control module
has a malfunction.
Possible Causes
- Driver-side curtain air bag module connector malfunction
- Open or short circuit in the wiring harness between the driver-side
curtain air bag
module and SAS control module
- Driver-side curtain air bag module malfunction
- SAS control module malfunction
System Wiring Diagram

Diagnostic Procedure




DTC B1128:55/B1129:55
System Malfunction Location

Detection Condition
WARNING:
- Detection conditions are for understanding the DTC outline before
performing an
inspection. Performing an inspection according to only the detection
conditions may
cause injury due to an operating error, or damage the system. When
performing an
inspection, always follow the inspection procedure.
- SAS control module configuration setting has not been done correctly
Possible Causes
- SAS control module configuration setting not implemented
- SAS control module configuration setting invalid
- SAS control module malfunction
Diagnostic Procedure


READ NEXT:
System Malfunction Location
Detection Condition
WARNING:
Detection conditions are for understanding the DTC outline before
performing an
inspection. Performing an inspection according to only th
System Malfunction Location
DSC HU/CM communication fault
Detection Condition
WARNING:
Detection conditions are for understanding the DTC outline before
performing an inspection. Performing an
System Malfunction Location
Detection Condition
WARNING:
Detection conditions are for understanding the DTC outline before
performing an
inspection. Performing an inspection according to only th
SEE MORE:
NOTE:
If the self-test is implemented, the seat weight sensor calibration is
performed. Perform
the DTC inspection in accordance with the following conditions:
Do not place objects on the front seat (passenger side)
Do not touch the front seat (passenger side)
Fix the slide position of th
System Malfunction Location
Detection Condition
WARNING:
Detection conditions are for understanding the DTC outline before
performing an
inspection. Performing an inspection according to only the detection
conditions may
cause injury due to an operating error, or damage the system. When
p
© 2016-2022 Copyright www.m2info.net
