Mazda 2: DTC B1127:11/B1127:12/B1127:13/B1127:19/B1127:1A
Mazda 2 2007-2014 Service Manual / Restraints / DTC / DTC B1127:11/B1127:12/B1127:13/B1127:19/B1127:1A
System Malfunction Location
Detection Condition
WARNING:
- Detection conditions are for understanding the DTC outline before performing an inspection. Performing an inspection according to only the detection conditions may cause injury due to an operating error, or damage the system. When performing an inspection, always follow the inspection procedure.
- Resistance other than 1.54-8.27 ohms detected in passenger-side side air bag module circuit
- Wiring harness between the passenger-side side air bag module and SAS control module has a malfunction.
Possible Causes
- Passenger-side side air bag module connector malfunction
- Open or short circuit in the wiring harness between the passenger-side side air bag module and SAS control module
- Passenger-side side air bag module malfunction
- SAS control module malfunction
System Wiring Diagram
Diagnostic Procedure
READ NEXT:
DTC B1128:11/B1128:12/B1128:13/B1128:19/B1128:1A
System Malfunction Location
Detection Condition
WARNING:
Detection conditions are for understanding the DTC outline before
performing an
inspection. Performing an inspection according to only th
DTC B1129:11/B1129:12/B1129:13/B1129:19/B1129:1A
System Malfunction Location
Detection Condition
WARNING:
Detection conditions are for understanding the DTC outline before
performing an
inspection. Performing an inspection according to only th
DTC U0028:88
System Malfunction Location
DSC HU/CM communication fault
Detection Condition
WARNING:
Detection conditions are for understanding the DTC outline before
performing an inspection. Performing an
SEE MORE:
Floor Mat
WARNING
Make sure the fl oor mats are secured
with the grommets or the retainers to
prevent them from bunching up under
the foot pedals (Driver's side):
Using a fl oor mat that is not secured is
dangerous as it will interfere with the
accelerator and brake pedal operation
(driver's side), wh
Manual Transaxle Operation
Manual Transaxle Shift Pattern
The vehicle is equipped with either a
5-speed or 6-speed manual transaxle. The
shift pattern for each is shown above.
Depress the clutch pedal all the way down
while shifting; then release it slowly.
Your vehicle is equipped with a device to
prevent shif
© 2016-2021 Copyright www.m2info.net