Mazda 2: DTC B10FE:11/B10FE:13/B10FE:87/B10FE:96
System Malfunction Location
Detection Condition
WARNING:
- Detection conditions are for understanding the DTC outline before performing an inspection. Performing an inspection according to only the detection conditions may cause injury due to an operating error, or damage the system. When performing an inspection, always follow the inspection procedure.
- Wiring harness between passenger-side side air bag sensor and SAS control module has a malfunction.
- Passenger-side side air bag sensor has a malfunction.
Possible Causes
- Passenger-side side air bag sensor connector malfunction
- Open or short circuit in the wiring harness between the passenger-side side air bag sensor and SAS control module
- Passenger-side side air bag sensor malfunction
- SAS control module malfunction
System Wiring Diagram
Diagnostic Procedure
READ NEXT:
DTC B1126:11/B1126:12/B1126:13/B1126:19/B1126:1A
System Malfunction Location
Detection Condition
WARNING:
Detection conditions are for understanding the DTC outline before
performing an
inspection. Performing an inspection according to only th
DTC B1127:11/B1127:12/B1127:13/B1127:19/B1127:1A
System Malfunction Location
Detection Condition
WARNING:
Detection conditions are for understanding the DTC outline before
performing an
inspection. Performing an inspection according to only th
DTC B1128:11/B1128:12/B1128:13/B1128:19/B1128:1A
System Malfunction Location
Detection Condition
WARNING:
Detection conditions are for understanding the DTC outline before
performing an
inspection. Performing an inspection according to only th
SEE MORE:
Automatic Transaxle Controls
Various Lockouts:
Indicates that you must depress
the brake pedal and hold in the lock-release
button to shift (The ignition must be switched ON).
Indicates the selector lever can
be shifted freely into any position.
Indicates that you must hold in
the lock-release button to shift.
NO
Accessory Sockets
Only use genuine Mazda accessories or
the equivalent requiring no greater than
120 W (DC 12 V, 10 A).
The ignition must be switched to ACC or
ON.
Type A
Type B
CAUTION
To prevent accessory socket damage
or electrical failure, pay attention to
the following:
Do not use accessories
© 2016-2021 Copyright www.m2info.net