Mazda 2: DTC B0011:11/B0011:12/B0011:13/B0011:19/B0011:1A
System Malfunction Location

Detection Condition
WARNING:
- Detection conditions are for understanding the DTC outline before
performing an
inspection. Performing an inspection according to only the detection
conditions may
cause injury due to an operating error, or damage the system. When
performing an
inspection, always follow the inspection procedure.
- Abnormal resistance (other than 1.54-5.06 ohms) detected in the
passenger-side air
bag module (inflator No.2) circuit
- Wiring harness between passenger-side air bag module (inflator No.2) and
SAS control
module has malfunction
Possible Causes
- Passenger-side air bag module (inflator No.2) connector malfunction
- Open or short circuit or short to ground or short to power supply in the
wiring harness between the passenger-side air bag module (inflator No.2) and
SAS control module
- Passenger-side air bag module (inflator No.2) malfunction
- SAS control module malfunction
System Wiring Diagram

Diagnostic Procedure




READ NEXT:
System Malfunction Location
Detection Condition
WARNING:
Detection conditions are for understanding the DTC outline before
performing an inspection. Performing an
inspection according to only th
System Malfunction Location
Detection Condition
WARNING:
Detection conditions are for understanding the DTC outline before
performing an
inspection. Performing an inspection according to only th
System Malfunction Location
Detection Condition
WARNING:
Detection conditions are for understanding the DTC outline before
performing an
inspection. Performing an inspection according to only th
SEE MORE:
BRAKE HOSE (FRONT) REMOVAL/INSTALLATION
1. Remove in the order indicated in the table.
2. Install in the reverse order of removal.
3. Add brake fluid, bleed the brakes, and inspect for leakage after the
installation has been completed. (See
BRAKE FLUID AIR BLEEDING).
Bolt
Bolt
Brake pipe
C
For optimum protection, the front seat
belts and rear outboard seat belts * are
equipped with pretensioner and load
limiting systems. For both these systems to
work properly you must wear the seat belt
properly.
Pretensioners:
When a collision is detected, the
pretensioners deploy simultaneo
© 2016-2021 Copyright www.m2info.net