Mazda 2: DTC B0002:11/B0002:12/B0002:13/B0002:19/B0002:1A
System Malfunction Location

Detection Condition
WARNING:
- Detection conditions are for understanding the DTC outline before
performing an inspection. Performing an
inspection according to only the detection conditions may cause injury due
to an operating error, or damage
the system. When performing an inspection, always follow the inspection
procedure.
- Abnormal resistance (other than 1.76-5.06 ohms) detected in the
driver-side air bag module (inflator
No.2) circuit
- Malfunction in the wiring harness between the driver-side air bag module
(inflator No.2) and SAS control
module
Possible Causes
- Driver-side air bag module (inflator No.2) connector malfunction
- Open or short circuit or short to ground or short to power supply in the
wiring harness between the clock
spring and SAS control module
- Clock spring malfunction
- Driver-side air bag module (inflator No.2) malfunction
- SAS control module malfunction
System Wiring Diagram

Diagnostic Procedure



DTC B0002:55/B0011:55
System Malfunction Location

Detection Condition
WARNING:
- Detection conditions are for understanding the DTC outline before
performing an
inspection. Performing an inspection according to only the detection
conditions may
cause injury due to an operating error, or damage the system. When
performing an
inspection, always follow the inspection procedure.
- SAS control module configuration setting has not been done correctly
Possible Causes
- SAS control module configuration setting not implemented
- SAS control module configuration setting invalid
- Driver-side air bag module or passenger-side air bag module assembly
incorrect
- SAS control module malfunction
Diagnostic Procedure

DTC B0003:53
System Malfunction Location
- Operation (deployment) inhibited due to configuration setting
Detection Condition
WARNING:
- Detection conditions are for understanding the DTC outline before
performing an
inspection. Performing an inspection according to only the detection
conditions may
cause injury due to an operating error, or damage the system. When
performing an
inspection, always follow the inspection procedure.
- The SAS control module configuration has not been set and other DTCs
present
Possible Causes
- The SAS control module configuration has not been set and other DTCs
present
Diagnostic Procedure


READ NEXT:
System Malfunction Location
Detection Condition
WARNING:
Detection conditions are for understanding the DTC outline before
performing an
inspection. Performing an inspection according to only th
System Malfunction Location
Detection Condition
WARNING:
Detection conditions are for understanding the DTC outline before
performing an
inspection. Performing an inspection according to only th
System Malfunction Location
Detection Condition
WARNING:
Detection conditions are for understanding the DTC outline before
performing an inspection. Performing an
inspection according to only th
SEE MORE:
ENGINE REMOVAL/INSTALLATION
WARNING:
Fuel vapor is hazardous. It can very easily ignite, causing serious
injury and damage. Always keep sparks and flames away
from fuel.
Fuel line spills and leakage are dangerous. Fuel can ignite and cause
serious injuries or death and damage. Fuel can also
CLOCK SPRING REMOVAL/INSTALLATION
1. Switch the ignition to off.
2. Disconnect the negative battery cable and wait for 1 min or more.
3. Remove the following parts:
Driver-side air bag module (See DRIVER-SIDE AIR BAG MODULE
REMOVAL/INSTALLATION).
Steering wheel (See STEERING WHEEL AND COLUMN R
© 2016-2022 Copyright www.m2info.net
