Mazda 2: DTC B0001:11/B0001:12/B0001:13/B0001:19/B0001:1A
System Malfunction Location

Detection Condition
WARNING:
- Detection conditions are for understanding the DTC outline before
performing an inspection.
Performing an inspection according to only the detection conditions may
cause injury due to an
operating error, or damage the system. When performing an inspection, always
follow the
inspection procedure.
- Resistance other than 1.76-5.06 ohms detected in driver-side air bag
module (inflator
No.1) circuit
- Wiring harness between driver-side air bag module (inflator No.1) and
SAS control module has
malfunction
Possible Causes
- Clock spring connector malfunction
- Clock spring malfunction
- Open or short circuit in the wiring harness between the clock spring and
SAS control module
- Driver-side air bag module (inflator No.1) malfunction
- SAS control module malfunction
System Wiring Diagram

Diagnostic Procedure




DTC B0001:55/B0010:55
System Malfunction Location

Detection Condition
WARNING:
- Detection conditions are for understanding the DTC outline before
performing an
inspection. Performing an inspection according to only the detection
conditions may
cause injury due to an operating error, or damage the system. When
performing an
inspection, always follow the inspection procedure.
- SAS control module configuration setting has not been done correctly
Possible Causes
- SAS control module configuration setting not implemented
- SAS control module configuration setting invalid
- SAS control module malfunction
Diagnostic Procedure


READ NEXT:
System Malfunction Location
Detection Condition
WARNING:
Detection conditions are for understanding the DTC outline before
performing an inspection. Performing an
inspection according to only th
System Malfunction Location
Detection Condition
WARNING:
Detection conditions are for understanding the DTC outline before
performing an
inspection. Performing an inspection according to only th
System Malfunction Location
Detection Condition
WARNING:
Detection conditions are for understanding the DTC outline before
performing an
inspection. Performing an inspection according to only th
SEE MORE:
If the vehicle battery is dead or there is a
malfunction in the electrical system and
the liftgate/boot lid can not be opened,
perform the following procedure as an
emergency measure to Open it:
(Hatchback)
CAUTION
Perform the procedure using a cloth
to cover sharp edges which could
in
TRANSAXLE FLUID TEMPERATURE (TFT) SENSOR INSPECTION
CAUTION:
Water or foreign objects entering the connector can cause a poor
connection or
corrosion. Be sure not to drop water or foreign objects on the connector
when
disconnecting it.
On-Vehicle Inspection
1. Disconnect the coupler compone
© 2016-2022 Copyright www.m2info.net
