Mazda 2: Driver/Passenger-side Air Bag Module
DRIVER-SIDE AIR BAG MODULE REMOVAL/INSTALLATION
WARNING:
- Handling the air bag module improperly can accidentally deploy the air
bag module, which may seriously injure you. Read the air
bag system service warnings and cautions before handling the air bag module.
(See AIR BAG SYSTEM SERVICE WARNINGS). (See
AIR BAG SYSTEM SERVICE CAUTIONS).
1. Switch the ignition to off.
2. Disconnect the negative battery cable and wait for 1 min or more.
3. Remove the bolts.

4. Using a flathead screwdriver, lift the locking device carefully, however
do not remove it.

5. Disconnect the air bag module connector.
6. Disconnect the horn switch connector.
7. Remove the driver-side air bag module.
8. Install in the reverse order of removal.
9. Switch the ignition to ON.
10. Verify that the air bag system warning light illuminates for approx. 6 s and
goes out.
- If the air bag system warning light does not operate normally, refer to
the on-board diagnostic system (air bag system)
and perform inspection of the system. (See FLOWCHART).
PASSENGER-SIDE AIR BAG MODULE REMOVAL/INSTALLATION
WARNING:
- Handling the air bag module improperly can accidentally deploy the air
bag module, which may seriously injure you. Read
the air bag system service warnings and cautions before handling the air bag
module. (See AIR BAG SYSTEM SERVICE
WARNINGS). (See AIR BAG SYSTEM SERVICE CAUTIONS).
1. Switch the ignition to off.
2. Disconnect the negative battery cable and wait for 1 min or more.
3. Remove the glove compartment (See GLOVE COMPARTMENT REMOVAL/INSTALLATION).
4. Disconnect the air bag module connector.

5. Remove the bolts.

6. Remove the screw.
7. Lift the passenger-side air bag module in the direction of arrow (1) as shown
in the figure.

8. Pull the passenger-side air bag module in the direction of arrow (2) and
detach the hook (front) from the instrument panel.
9. Rotate the passenger-side air bag module in the direction of arrow (3).

10. Press the passenger-side air bag module in the direction of arrow (4) and
rotate it in the direction of arrow (5).
11. Pull the passenger-side air bag module downward (6) and remove it.
12. Install in the reverse order of removal.
13. Switch the ignition to ON.
14. Verify that the air bag system warning light illuminates for approx. 6 s and
goes out.
- If the air bag system warning light does not operate, refer to the
on-board diagnostic system (air bag system)
and perform inspection of the system. (See FLOWCHART).
READ NEXT:
SIDE AIR BAG MODULE REMOVAL/INSTALLATION
WARNING:
Handling the air bag module improperly can accidentally operate (deploy)
the air bag
module, which may seriously injure you. Read the air bag sys
CURTAIN AIR BAG MODULE REMOVAL/INSTALLATION
WARNING:
Handling the air bag module improperly can accidentally deploy the air
bag module, which may seriously injure you. Read the air
bag system ser
CRASH ZONE SENSOR REMOVAL/INSTALLATION
WARNING:
Handling the crash zone sensor improperly can accidentally deploy the
air bags and
pre-tensioner seat belts, which may seriously injure you. Read t
SEE MORE:
The parking sensor system uses ultrasonic sensors to detect obstructions
around the vehicle
while parking the vehicle in a garage or during parallel parking when the shift
lever is
in reverse (R). The system is equipped with an assist device to notify the
driver of the
approximate distance
INTERMEDIATE SHAFT REMOVAL/INSTALLATION
WARNING:
The steering column (EPS motor) temperature increases directly after
continuous
turning of the steering mechanism which could cause burns if it is touched.
Before
performing any servicing, verify that the steering column has cooled off.
CAUTI
© 2016-2021 Copyright www.m2info.net