Mazda 2: Drive Plate
DRIVE PLATE REMOVAL/INSTALLATION
1. Remove the transaxle. (See AUTOMATIC TRANSAXLE REMOVAL/INSTALLATION).
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.

- Drive plate installation bolts
- Adapter
- Drive plate
Drive Plate Installation Bolts Removal Note
1. Set the SST against the drive plate.

2. Loosen the drive plate installation bolts uniformly in two or three steps
in the order shown
in the figure, then remove the bolts and the drive plate.
Drive Plate Installation Bolts Installation Note
1. Set the SST against the drive plate.

2. Tighten the new drive plate installation bolts uniformly in two or three
steps in the order
shown in the figure.
Tightening torque
- 97-103 N*m {9.9-10 kgf*m, 72-75 ft*lbf}
READ NEXT:
OIL SEAL REPLACEMENT
CAUTION:
The oil seal is easily damaged by the sharp edges of the drive shaft
splines. Do not let
the splines contact the oil seal.
1. Drain the ATF into a separate suitable
CONTROL VALVE BODY REMOVAL/INSTALLATION
On-Vehicle Removal
WARNING:
Using compressed air can cause dirt and other particles to fly out,
causing injury to the
eyes. Wear protective eyeglasses when
AUTOMATIC TRANSAXLE SHIFT MECHANISM LOCATION INDEX
Key cylinder
(See KEY INTERLOCK SYSTEM INSPECTION.)
Selector lever component
(See AUTOMATIC TRANSAXLE SHIFT MECHANISM REMOVAL/INSTALLATIO
SEE MORE:
Cell Phones Warning
WARNING
Please comply with the legal regulations concerning the use of
communication
equipment in vehicles in your country:
Use of any electrical devices such as cell phones, computers, portable radios,
vehicle
navigation or other devices by the driver while the vehicle
PURGE SOLENOID VALVE REMOVAL/INSTALLATION
1. Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION).
CAUTION:
Removing the fresh-air duct from the air cleaner case may damage the
fresh-air duct.
Always remove the fresh-air duct and the air cleaner case as a single unit.
2.
© 2016-2021 Copyright www.m2info.net